CWDP-304
Real Dumps
https://www.certspots.com/exam/cwdp-304/
CWDP-304 Real Dumps
1. To increase capacity in a coverage-based wireless network, which
of the following techniques are typically recommended? (Choose
all that apply.)
A. Maximize airtime usage by disabling lower data rates.
B. Add additional APs and use directional antennas.
C. Turn up power on the access points.
D. Lower power on the access points and, after careful planning,
add more AP
Answer: A B D
CWDP-304 Real Dumps
2. Who should be in the final meeting from the customer-side after
successfully implementing a WLAN infrastructure?
A. CEO or CFO
B. End-users
C. The customer's customers
D. Remote workers
Answer: B
CWDP-304 Real Dumps
3. A controller-based WLAN infrastructure has its controller on a
different subnet than its APs.
What device must be used to enable any communication between
the Controller and the APs?
A. NTP server
B. Router
C. PoE Layer 2 switch
D. Wireless bridge
Answer: B
CWDP-304 Real Dumps
4. You are conducting a physical site survey where heavy machinery
is repaired.
What is a common item required specifically for this type of survey?
A. Personal Protective Equipment (PPE)
B. Low gain antennas
C. Low power APs
D. Indoor APs
Answer: A
CWDP-304 Real Dumps
5. For what purposes are VPNs typically used in modern WLANs? (Choose all
that apply.)
A. Remote AP tunneling to a corporate WLAN controller or VPN concentrator
B. Client device connectivity to corporate resources from unsecured public
networks
C. Initial 802.11 authentication with the AP and subsequent data encryption
D. Tunneling APs and WLAN controllers to cloud-based management
platforms
E. Tunneling APs and WLAN controllers to RADIUS and token servers
F. Bridging client connectivity in ad hoc networks
Answer: A B
CWDP-304 Real Dumps
6. A controller-based WLAN infrastructure has its controller on a
different subnet than its APs.
What device must be used to enable any communication between the
Controller and the APs?
A. NTP server
B. Router
C. PoE Layer 2 switch
D. Wireless bridge
Answer: B
CWDP-304 Real Dumps
7. Which one of the following is an essential metric to measure when
performing a survey and design for VoIP across WLANs?
A. Throughput rates above 50 Mbps
B. Data rates above 100 Mbps
C. Latency
D. PoE provided to wireless handsets
Answer: C
CWDP-304 Real Dumps
8. During a post-validation assessment, you have configured a client for
802.1X/EAP but it is not passing authentication.
Which areas should you check in the WLAN configuration?
A. Whether the RADIUS server is online and configured for the matching port
on the APs and WLAN controllers
B. Whether the RADIUS shared secret is properly configured on the supplicant
and authentication server
C. Whether the authenticator is configured to support the EAP type(s) your
client is configured for
D. Whether the client has a fully valid certificate
Answer: A
CWDP-304 Real Dumps
9. When installing a cloud-based AP, what is the most common process used?
A. Configure the AP as an autonomous AP and then, when it connects to the
cloud, it will be reconfigured.
B. Configure a profile for the AP in the cloud and then connect it for
automatic configuration.
C. Connect the AP to the network and configure it from the cloud assigning a
configuration or policy set to the AP.
D. Configure the AP with a local controller and then, when it connects to the
cloud, it will be reconfigured.
Answer: B
CWDP-304 Real Dumps
10. What limitation exists when WMM is not enabled on an 802.11n
WLAN?
A. The maximum channel-width will be 20MHz
B. Only two ACs will be available
C. EDCA values will change
D. 802.11 QoS will not be available
Answer: D