Ain Shams University
Faculty of Engineering
Mechanical Engineering Drawing (MDP111)
Inventor Project Instructions
Requirements:
1. Create the project file.
2. Create 2D sketch and 3D modeling for each part (Standard (mm). ipt)
3. Create complete assembly for the parts using the assembly constrain
method (Standard (mm). iam).
4. Create final drawing for each part and for the assembly, (ISO. idw).
5. Create an animation video for the assembly.
Submission (Soft Copy):
• You are required to submit the following:
i.
ii.
iii.
iv.
v.
The project file.
The ipt file for each part (Milestone one 22/11/2023).
The iam assembly file (Milestone Two 6/12/2023).
The idw and pdf files for the drawing (Milestone Three 20/12/2023).
The animation video (Milestone Four 27/12/2023).
• Note: The project will be submitted individually through LMS
according to each milestone date.
Good luck