O‘ZBEKISTON RESPUBLIKASI RAQAMLI TEXNOLOGIYALAR
VAZIRLIGI MUHAMMAD AL-XORAZMIY NOMIDAGI
TOSHKENT
AXBOROT
TEXNOLOGIYALARI
UNIVERSITETI
Kompyuter injiniringi fakulteti
Sun’iy intellekt kafedrasi
IoT texnologiyalari fanidan
1-Amaliy ish
Bajardi: 222-21 guruh talabasi
Yusubjonov Boxodir
Tekshirdi: Ma‘mirov Xudoyberdi
TOSHKENT 2023
1-amaliy ish.
Tinkercad.com virtual laboratoriya yordamida LED(fotodiodni yoqib o‘chirish, 1 va 2 ta
fotodiodni yoqib o‘chirish va svetofor dasturini tuzish) va Arduino kit yordamida
yig‘ish va ishlatish.
// C++ code
//
int qizil = 2;
int sariq = 4;
int yashil = 6;
void setup()
{
pinMode(qizil, OUTPUT);
pinMode(sariq, OUTPUT);
pinMode(yashil, OUTPUT);
Serial.begin(9600);
}
void loop()
{
Serial.println("Qizil");
digitalWrite(qizil, HIGH);
digitalWrite(sariq, LOW);
digitalWrite(yashil, LOW);
delay(25000);
Serial.println("Qizil\tSariq");
digitalWrite(qizil, HIGH);
digitalWrite(sariq, HIGH);
digitalWrite(yashil, LOW);
delay(4000);
Serial.println("Sariq");
digitalWrite(qizil, LOW);
digitalWrite(sariq, HIGH);
digitalWrite(yashil, LOW);
delay(6000);
Serial.println("Yashil");
digitalWrite(qizil, LOW);
digitalWrite(sariq, LOW);
digitalWrite(yashil, HIGH);
delay(15000);
}