Smart Home App
Operating instructions
Revision 1.8 English Release 03/2021
Smart Home App, operating instructions © Wise Home Technologies, All rights
reserved.
This document may contain errors. However, it is regularly reworked and
appropriately corrected in the next release. For substantive errors, we assume no
liability.
Section 1 - Important safety information
Caution: Don’t turn on hazardous consumers via the app when you are not nearby or have a
reliable overview of the situation at your facility. If you are not sure, for example, if you
turned off your iron, it makes perfect sense to switch off the appropriate power socket, even
and especially when you are not on site.
You should never turn on power sockets from far away when you are not absolutely
sure that hazardous consumers are connected.
Section 2 - General Information
Who should read this document?
This document is for persons, who set up the Smart Home App or use the smart home app
to configure, monitor, or control a smart home system.
Safety and privacy
Your safety and the safety of your properties are our first priority. Therefore, we
implemented sophisticated methods to protect your safety and privacy. As an operator,
however, you have to pay attention to some basic safety concepts in order to not
compromise the safety of your installation.
Section 3 - Operation
After downloading and launching the Smart Home App, the app will instruct you on setting
up your smart home network and connecting all of your smart devices to the app. You
should, however, pay close attention to the following important steps:
●
●
●
●
The app is in “view only” mode unless you enter your 4 digit PIN.
The default PIN is 1110.
It is critical that you change the default PIN during the setup process.
Failing to change the default PIN might allow unauthorized users to control your
smart devices.
Section 4 - Configuration
Before you can control your smart home devices via the app, it has to be configured first.
The Smart Home App was built to walk you through the interactive configuration process.
The configuration will be stored on your device and on your Smart Home Cloud account, so
you can restore it anytime. In addition, some devices already have a predefined
configuration that suits most of the users.