Sketchbook Binding
1.
Fold all papers in half individually
2.
Place pages in the middle of the paper, line up the middle fold, binder clip the papers
3.
Use your ruler, on the fold mark 1 inch down from the top, 4 inches down from the top,
and one inch from the bottom.
4.
Use the awl to poke a hole on each of the marks
5.
Put your thread through the needle. Pull the thread until both sides are even
6.
Put the needle in the middle hole or your sketchbook pull it through being careful to
hold the thread
7.
Bring the thread to the bottom hole pull it through
8.
Go around the bottom and pull the needle through the same bottom hole
9.
Bring the thread through the middle hole
10.
Bring the thread to the top hole and pull through
11.
Go around the top and bring it through the top hole again
12.
Bring the thread to the middle and tie 2 knots to the original piece of thread