MSE 100 Engineering Graphics and Software for Design Assignment 4 You have the option to do the assignment digitally (on your laptop or tablet) and submit it directly to canvas in pdf format. If you did it on paper, please scan/take picture of your solutions, convert and combine them all into ONE pdf file, and upload them on Canvas. Question 1 – Section View Re-sketch the views shown and add a cross-sectional view as indicated by the cutting plane. Note: Use the graph papers provided at the end of the document. 1 2 3 MSE 100 Ahad Armin, Ph.D., P. Eng. Question 2 – Removed Section View The front view of an object is given below along with 4 cross-sectional views looking at the front of the object to the back, as well as a plan cross-sectional view looking down at the object. The object’s dimensions are 5 x 6 x 5 units. Draw the isometric view of the object. Note: Use the isometric graph paper provided at the end of the document. Front Multiview Cross-section taken 1 unit below the top face of the object looking downwards Cross-sections taken 1 unit from the front face of the object Cross-sections taken 2 units from the front face of the object Cross-sections taken 3 units from the front face of the object Cross-sections taken 5 units from the front face of the object MSE 100 Ahad Armin, Ph.D., P. Eng.