HPE7-A01
Dumps
https://www.certspots.com/exam/hpe7-a01/
HP HPE7-A01 Dumps
1. Which statement best describes QoS?
A. Determining which traffic passes specified quality metrics
B. Scoring traffic based on the quality of the contents
C. Identifying specific traffic for special treatment
D. Identifying the quality of the connection
Answer: C
HP HPE7-A01 Dumps
2. Which statements regarding Aruba NAE agents are true? (Select two )
A. A single NAE script can be used by multiple NAE agents
B. NAE agents are active at all times
C. NAE agents will never consume more than 10% of switch processor resources
D. NAE scripts must be reviewed and signed by Aruba before being used
E. A single NAE agent can be used by multiple NAE scripts.
Answer: A D
HP HPE7-A01 Dumps
3. Which method is used to onboard a new UXI in an existing environment with
802 1X authentication? (The sensor has no cellular connection)
A. Use the UXI app on your smartphone and connect the UXI via Bluetooth
B. Use the Aruba installer app on your smartphone to scan the barcode
C. Connect the new UXI from an already installed one and adjust the initial
configuration.
D. Use the CLI via the serial cable and adjust the initial configuration.
Answer: A
HP HPE7-A01 Dumps
4. What is an Aruba-recommended best practice for hardening that only applies
to Aruba CX 6300 series switches with dedicated management ports?
A. Implement a control plane ACL to limit access to approved IPs and/or
subnets
B. Manually enable Enhanced Security Mode from a console session.
C. Disable all management services on the default VRF.
D. Create a dedicated management VRF, and assign the management port to it.
Answer: D
HP HPE7-A01 Dumps
5. Which Aruba AP mode is sending captured RF data to Aruba Central for
waterfall plot?
A. Hybrid Mode
B. Air Monitor
C. Spectrum Monitor
D. Dual Mode
Answer: C
HP HPE7-A01 Dumps
6. What is an OSPF transit network?
A. a network that uses tunnels to connect two areas
B. a special network that connects two different areas
C. a network on which a router discovers at least one neighbor
D. a network that connects to a different routing protocol
Answer: B
HP HPE7-A01 Dumps
7. A customer is using a legacy application that communicates at layer-2. The
customer would like to keep this application working across the campus which
is connected via layer-3. The legacy devices are connected to Aruba CX 6300
switches throughout the campus.
Which technology minimizes flooding so the legacy application can work
efficiently?
A. Generic Routing Encapsulation (GRE)
B. EVPN-VXLAN
C. Ethernet over IP (EolP)
D. Static VXLAN
Answer: B
HP HPE7-A01 Dumps
8. Using Aruba best practices what should be enabled for visitor networks where
encryption is needed but authentication is not required?
A. Wi-Fi Protected Access 3 Enterprise
B. Opportunistic Wireless Encryption
C. Wired Equivalent Privacy
D. Open Network Access
Answer: B
HP HPE7-A01 Dumps
9. You need lo have different routing-table requirements with Aruba CX 6300
VSF configuration Assuming the correct layer-2 VLAN already exists how would
you create a new OSPF configuration for a separate routing table?
A. Create a new OSPF area, and attach VRF name.
B. Create a new OSPF process ID with vrf name.
C. Attach a new OSFP process ID with a custom routing table
D. Attach OSPF process ID in the VRF configuration.
Answer: B
HP HPE7-A01 Dumps
10. A company recently deployed new Aruba Access Points at different branch
offices Wireless 802.1X authentication will be against a RADIUS server in the
cloud. The security team is concerned that the traffic between the AP and the
RADIUS server will be exposed..
What is the appropriate solution for this scenario?
A. Enable EAP-TLS on all wireless devices
B. Configure RadSec on the AP and Aruba Central.
C. Enable EAP-TTLS on all wireless devices.
D. Configure RadSec on the AP and the RADIUS server
Answer: D