Uploaded by Irfan ul haque

2G SSV test Guide Procedure

advertisement
2G SSV Test Guide
www.huawei.com
Huawei Confidential
Drive-test Data needed for SSV Test:
Items
Data needed
1
Engineering paramters
2
Map
Description
the 2G site Information ( BCCH, BSIC, LAC ,CI)
Check whether the Latitude, Longitude & azimuth provided in Engineering parameters are Correct
Huawei Confidential
Page 2
1st test to check the 2G site information.
1.
2.
3.
4.
5.
Before moving to the site you have to contact the OMC engineer or RF engineer to be sure the site is
activated and doesn't have any alarms and all the service is activated on the site.
If the answer from the OMC engineer or RF Engineer is OK so we can start our SSV test.
After connecting you mobiles to the probe and confirm its connected on the Software the first test will
be checking the site information.
From the window of the UE State (View=> GSM=> GSM Radio Parameters) check CGI (MCC,MNC, LAC,
CI), Rx Level Full for Idle & Rx Level Sub for Dedicated.
You have to confirm the Data you get from the test is typical like the data from the engineering
parameter then you have to fill the following table.
Cell 1
No.
Cell 2
Cell 3
Activity / Process
Planned Found Planned Found Planned Found
1
BCCH as planned
2
BSIC as planned
3
Cross Connections checked
4
Rx Level > -85 dBm Near Site
Yes
Yes
Yes
5
Rx Quality< 2 Near Site
Yes
Yes
Yes
7
intra site handover normally
Yes
Yes
Yes
8
MOC & MTC normal
Yes
Yes
Yes
9
GPRS service is checked
Yes
Yes
Yes
Configuration
Installation
Coverage
Service
Huawei Confidential
Page 3
How to discover the cross sector.
1.
2.
3.
After you Check the BCCH & BSIC for each cell.
You have to compare it with the engineering parameter data.
And if you found BCCH from the field is not matching the data from the engineering parameters in this
case we can say it’s cross sector.
A. This case doesn't have a cross sector
Huawei Confidential
Page 4
Drive-Test Methodology

We have to type of tests:
1.
Stationary Test (For Function Check under each sector)
2.
Mobility Test (To check coverage of the site)
Huawei Confidential
Page 5
Stationary Test & Mobility test

The stationary test will be under each sector.

We will be standing under the sector (not moving by car) to have a
good RX level to make the function check.

Check the Handover between all the sector clock wise & Anticlock wise
and Handover with the Neighboring site
Drive test route
Stationary test point
* Note:- The position you choose should be in LOS with antenna
Huawei Confidential
Test log Naming rules

Folder name for every site
XXXXX=SW+Site Name+mm+dd+YYYY

With 3 Sub folders for every sector with the CI & one for SSV
Huawei Confidential
Thank You
www.huawei.com
www.huawei.com
Huawei Confidential
Download