Problem 110 A 12-inches square steel bearing plate lies between an 8-inches diameter wooden post and a concrete footing as shown in Fig. P-110. Determine the maximum value of the load P if the stress in wood is limited to 1800 psi and that in concrete to 650 psi. ________________________________________________ Problem 136 A cylindrical pressure vessel is fabricated from steel plating that has a thickness of 20 mm. The diameter of the pressure vessel is 450 mm and its length is 2.0 m. Determine the maximum internal pressure that can be applied if the longitudinal stress is limited to 140 MPa, and the circumferential stress is limited to 60 MPa. ________________________________________________ Problem 127 In the clevis shown in Fig. 1-11b, find the minimum bolt diameter and the minimum thickness of each yoke that will support a load P = 14 kips without exceeding a shearing stress of 12 ksi and a bearing stress of 20 ksi. Plot the stress-strain diagram and determine the following mechanical properties: (a) proportional limit; (b) modulus of elasticity; (c) yield point; (d) yield strength at 0.2% offset; (e) ultimate strength; and (f) rupture strength. ________________________________________________ Example 1-4 Calculate the maximum shear stress τmax in a simply supported wood beam carrying a uniform load of (w=18 kN/m) if the length is 1.75 m and the cross section is rectangular with width 150 mm and height 250 mm. ________________________________________________ Problem 204 The following data were obtained during a tension test of an aluminum alloy. The initial diameter of the test specimen was 0.505 in. and the gage length was 2.0 in. ________________________________________________ References A. Mathalino. (n.d.). Solution to Problem 110 Normal Stress. Retrieved May 24, 2023 https://mathalino.com/reviewer/mechanics-and-strength-of-materials/solution-to-problem-110-normal-stress from B. Mathalino. (n.d.). Solution to Problem 127 Bearing Stress. Retrieved May 24, 2023 https://mathalino.com/reviewer/mechanics-and-strength-of-materials/solution-to-problem-127-bearing-stress from C. Mathalino. (n.d.). Solution to Problem 136 Pressure Vessel. Retrieved May 24, 2023 https://mathalino.com/reviewer/mechanics-and-strength-of-materials/solution-to-problem-136-pressure-vessel from D. Uomustansiriyah. (n.d.). Example 1-4. Retrieved May https://uomustansiriyah.edu.iq/media/lectures/5/5_2018_02_21!10_28_49_PM.pdf from 24, 2023 E. Mathalino. (n.d.). Solution to Problem 204 Stress-Strain Diagram. Retrieved May 24, 2023 https://mathalino.com/reviewer/mechanics-and-strength-of-materials/solution-to-problem-204-stress-strain-diagram from