Let’s contribute to make RDC an incident free workplace!!!
• Understanding RDC Site Safety Rules.
• Understanding Roles and Responsibilities.
• Implementing the HSE requirements.
• Following safe practices to achieve 100% HSE.
• Avoid accident/incidents inside RDC.
Outbound Driver HSE
Campaign
Health, Safety & Environment is treated with utmost priority in RDC.
•
Before granting access to RDC, its mandatory to undergo site safety
induction for all visitors.
• Obey and comply with RDC HSE requirements &
Instructions.
• Obey all speed limits and traffic regulations.
• No littering! Maintain good housekeeping.
• Do not discard empty pallets/tires in RDC premises &
outside parking area.
• A
• No Smoking inside RDC premises.
• Wear seatbelt & do not use mobile phones while
driving.
• Be respectful and act in a well-mannered way to RDC
staffs.
• Once loading/offloading in progress, the driver
should switch off the engine and stay in designated
safe zone .
• Maintain good housekeeping and hygiene.
• Waste should be disposed properly in designated
waste bins.
• Eating allowed in designated restrooms.
• No arguing and fighting with RDC staffs.
• Use pedestrian lanes to cross the roads.
• Always inspect your trailer before the start of the
job.
• If any thing found damaged or faulty please inform
your supervisor.
•
•
•
•
Always follow the speed limit.
Secure the load with enough lashing.
Always check your load during midway stop.
Cover the material in adverse weather
conditions.
• Offload the material at designated area as
per client requirement.
• Always switch off the engine while loading
and off loading the material.
• Secure the load with enough lashing.
• Follow the speed limit.
• After lashing the material check around if
any Leaning.
• While turning the trailer be careful by
maintain slow speed.
• Avoid harsh brakes.
• Keep safe distance from the other vehicles.
• Always follow the speed limit.
• Secure the load with enough lashing.
• Always switch off the engine while loading
and off loading the material.
• Follow the speed limit.
Description on incident:
• While proceeding for offloading raw material and
turning near the Pump room Experts transports Raw
material trailer hit the suppliers water tanker.
Lesson Learnt:
 Always allow the vehicle to proceed for loading/off loading if the
route is clear.
 Stop the vehicle and wait if Some other vehicle is on the way.
 Security staff will escort the service provider vehicles and stop
all the traffic movements on the same route.
Description on incident:
• While proceeding for loading and turning
MICCO truck hit Gulftainer Truck in
Outbound Truck Parking 2.
Lesson Learnt:
• Always parked the vehicle by leaving
beside parking empty.3
• Always check both sides of the vehicles
while enter or exit the truck parking.
• Please note the blind spot to avoid ant
accident.
Description on incident:
•
Outbound loaded Truck trailer hit the security
barrier and newly installed gate Thereby
damaging the gate and the security barrier.
Loaded material was also damaged due to this
incident.
Lesson Learnt:
•
•
•
•
Slow down the speed while exit the security
check point.
Don’t take sharp turn while exit the main gate.
There is main gate after security check point
please be careful while moving.
Follow the security staff instruction and traffic
management plan of RDC.
Description on incident:
•
Securing/Fastening the material using lashing
belts.
Lesson Learnt:
•
•
•
•
Always parked the truck on proper designated
place.
Do not move the truck while lashing.
Lashing the material by check on both side to
avoid any material damaged because of
lashing belt hook.
Fix the Hook on proper designated place after
that tighten the belt.