Busbars by
Second insulation
Polymerised resin (polyester
or epoxy) reinforced with mineral
charges
First insulation
Tape along the entire length
3 phases
Type test according with the standards:
IEC60439- 1 & 2:
Temperature-rise limits (conductors and enclosure):
Verification of the dielectric properties
Degree of protection (IP66-IP68)
Verification of clearances and creepage distances
Verification of the structural strength with normal mechanical loads
Determination of resistance, reactance and impedances values
3 phases
+ N (50%)
3 phases + N (100%)
or (2N - 50%)...
Fire resistance test according with
the standards IEC60439- 1&2:
• Resistance to abnormal heat and fire
• Verification of resistance to
flame-propagation
• Verification of fire resistance
First insulation
Heat-shrinkable medium
voltage tube
Second insulation
Polymerised resin (polyester
or epoxy) reinforced with mineral
charges
Metal enclosure
Standard IEC60271-200
(5.102)
Resin blocks
Fixing the phases together
Short-circuits withstanding
Limit the spread of fire
Mounting profiles
Type test according with the standards: IEC60271-200 and IEC62271-1
Conductor contact
Can be delivered as
a crimped or mechanical
contact
Internal screen
Prevents partial
discharges
External screen
3 mm thick EPDM
rubber jacket is
moulded to the
connector insulation
• No minimum distances required: can be
installed in compact substations
• Safe to touch when energized
• Maintenance free
• Quick and easy to install without special tools
• Easy to disconnect
• Fully watertight
• Degree of protection IP67:
dust tight & immersion in water
• Resistant to UV, ozone, chemicals,
mechanical abuse
• Temperature range from -30°C to +110°C
• Offers many test options: capacitive test
point, cable tests ...
• A complete range for 12 to 42 kV
and from 250 to 2500 A.
Type tested according with CENELEC HD 629.1
• Cold-shrinkable products for easy installation
• Slip-on products up to 42 kV and 1000 mm²
• Moulded in high quality silicone rubber
• Cold-shrinkable solutions for any single core
and three core cable
• One single movement installation
• Solutions for 12, 24 and 36 kV,
covering a range of cables
Conductor contact
from 35 mm² up to 1000 mm²
Can be delivered as
• Reliable transition joints for belted
a crimped or mechanical
and individually screened cables.
contact
Type tested according with CENELEC HD 629.1
All our products have been tested in our independant, accredited lab.
Nexans • 4/2011
Additional catalogue information on power cable accessories
is available by contacting us at the address below:
Nexans Network Solution N.V. - Div. Euromold • Zuid III, Industrielaan 12, B-9320 Erembodegem • Belgium
Tel.: +32 (0)53 85 02 11 • Fax: +32 (0)53 83 10 13 • www.nexans.com • sales.euromold@nexans.com
Catalogue also available on CD-ROM