Assessment 1 – Test Preamble
Online Test
CSE2CNX Computer Networks
Before you begin
Objectives
•
•
•
•
Apply knowledge on basic networking concepts
Apply knowledge on layer 2 switching
Apply knowledge on VLAN and Inter-VLAN routing
Apply knowledge on IPv6 & Configuration of IPv6
This is an individual assignment. Students are not permitted to work in a group when writing this
assignment.
Copying and Plagiarism
This is an individual assignment. Students are not permitted to work in a group when writing this
assignment. Plagiarism is the submission of another person’s work in a manner that gives the
impression that the work is their own. La Trobe University treats plagiarism seriously. When detected,
penalties are strictly imposed.
Further information can be found on http://www.latrobe.edu.au/students/academicintegrity/explanation/plagiarism
Submission Guidelines
•
•
•
•
2
Work should be submitted for each question via the LMS using the quiz.
The assessment is a 20-minutes assessment.
Your work can only be submitted during the 20 minutes from when you start.
The test can only be commenced, worked on, and submitted during the nominated sitting
times. You should apply for special consideration if you encounter difficulties.
© Didasko 2022. All rights reserved.
2
Background
This test contains 15 multiple choice questions.
Listed below are the topics covered in this assessment.
•
•
•
•
•
•
•
•
Internetworking basics
Internetworking models (OSI model, TCP/IP model, Cisco three-layer hierarchical
model)
Ethernet Networking
Layer 2 switching & port security
Spanning Tree Protocol
IPv4 addressing & subnetting
IPv6 addressing & subnetting
VLAN and Inter-VLAN routing
The test runs on a twenty (20) minute timer from commencement and can only be completed
during the nominated sitting time of the exam week:
Day of week
Start of sitting
End of sitting
Time zone
Tuesday
7:00pm
11:00pm
Melbourne
As an example, if you start at 7:05pm then your timer will finish at 7:25pm. Also, if you start at
8:20pm then your timer will finish at 8:40pm. The whole of your test must be completed during
the sitting, otherwise it will be cut short.
Your test will be available to you automatically during the sitting.
Note that it is not possible to pause the test and resume later. Importantly the test is strictly
limited to one attempt only.
Before starting the test, you should complete the “CSE2CNX: Test Practice” activity, which will
familiarise yourself with the Moodle examination environment, web interface, and logistics.
If you have any questions about the test, make sure you submit a support request before you
start.
Test date can be found in your calendar.
(End of preamble.)
© Didasko 2022. All rights reserved.
3