Installation Manual STx Switch
EAE KNX Rosa Switch Series
Rosa IM R1.0
Operation and Display
Installation
Installation of the product is done with the help of the flange which is
inside the box. The flange is fixed to the junction box by using screws
while the arrows on flange are headed to up. The switch is placed into
the junction box by positioning the EAE logo upwards and then reclining
it to the flange. The switch is slowly turned clockwise to give the right
position to it on the flange. After the clicks are on the right position,
switch is turned counter-clockwise to lock it on the flange.
Locking Direction (CCW)
Locking Direction (CCW)
Description of the Device
Rosa premium push-button and thermostat series create a natural
harmony and adds value to your interior designs with elegant look and
sophisticated technology. Combined with KNX system, use of a single
Rosa switch would provide you the means to activating light scenes,
controlling blinds and setting a comfortable temperature. Rosa series
which combine the familiar push button feeling with the latest
technology are available in anthracite, ivory and cloud gray colours.
•
•
60x60 mm easy mounting to standard junction boxes.
4 rockers can be programmed to perform different functions.
▪ Switching
▪ Dimming
▪ Shutter/Blind
Connections
Installation
Temperature range
Humidity
Dimensions
Weight
Box
CE
Application Program
▪ Value
▪ Scene control
▪ Status notification
IP 20
-EN 60 529
II
-EN 61 140
- Voltage
21 V… 30 V DC SELV
- Current Consumption
≤ 10 mA
-KNX
Bus connection terminal
60x60 mm standard box
Ambient
-5° C + 45° C
Storage
-25° C + 55° C
Max. air humidity
95 % no moisture
condensation
Front face
85x85 mm
Side- Surface
11 mm
Side- Under plaster
19,4 mm
93 g
Plastic, polycarbonate
In accordance with the EMC guideline and low
voltage
Communication Objects
-50
Number of Addresses(max)
-254
Number of assignments(max)
-255
© EAE Technology
Ikitelli Org.San.Bolg. Ziya Gokalp Mah. Eski Turgut Ozal Cad.
No: 20 34490 Basaksehir/Istanbul Tel: +90 212 549 97 13
Device default physical address is 15.15.255. Determination of the
physical address and setting of parameters are actualized with
Engineering Tool Software (ETS3/ETS4 or higher). “.knxprod” file must be
imported to the ETS. (http://www.eaetechnology.com/)
A detailed information about parameter configuration can be found
in Product Manual of device.
Technical Data
Type of protection
Safety class
KNX Supply (1)
Commissioning
Installation and commissioning of device may only be implemented
by trained electricians. The relevant standards, directives, regulations
and instructions must be observed when planning and implementing the
electrical installation.
-When connecting the device make sure that the device can be isolated!
-Protect the device against moisture, dirt and damage during transport,
storage and operation!
-Do not operate the device out of the specified technical data which is
stated.
-The device may only be operated in closed enclosures (Distribution
boards)
Cleaning
If device becomes dirty, only a dry cloth can be used for cleaning. İt is not
suitable to use wet cloths, caustics and solvents.
www.eaetechnology.com