Ministry of Science and Technology Department of Advanced Science and Technology University of Technology (Yatanarpon Cyber City) Faculty of Electronic Engineering EcE-21021 Digital Electronics LAB I Name ……………………………… Roll No. ……………………………. Date ……………………………. (2022-2023) Academic Year Experiment-I LOGIC GATES 1.1 Objectives To study basic gates (AND, OR, NOT) and universal gates (NAND, NOR) and verify their truth tables. 1.2 Required Equipment - Digital ICs - Resistor 330Ω and 470Ω -Variable DC power supply - Jumper wires - LED -Bread Board 1.3 Pin Diagram of 555 Timer IC 7400(NAND) 7404(NOT) 7432(OR) 7402(NOR) 7408(AND) 7486(XOR) 1.4 Construct the circuit diagrams for digital ICs and fill the truth tables. I. NOT Gate Procedure Set NOT gate on the breadboard. Let pin 1 is an input and pin 2 as a output. Join the output pin 2 with resistor and LED. Pin 7 is connected to ground. Give a 5V-9V supply to pin 14. Jumper wires are used to connect all above connections. VCC 5V 1 R1 2 470Ω LED1 74LS04N 5V Truth Table for NOT Gate Input Output 0 1 II. AND Gate Procedure Set AND gate on the breadboard. Let pin 1 and 2 set as inputs and pin 3 as a output. Join the output pin 3 with resistor and LED. Pin 7 is connected to ground. Give a 5V-9V supply to pin 14. Jumper wires are used to connect all above connections. 1 3 2 74LS08N R1 330Ω 5V LED1 Truth Table for AND Gate Input Output 0 0 0 1 1 0 1 1 III. OR Gate Procedure Set OR gate on the breadboard. Let pin 1 and 2 set as inputs and pin 3 as a output. Join the output pin 3 with resistor and LED. Pin 7 is connected to ground. Give a 5V-9V supply to pin 14. Jumper wires are used to connect all above connections. 1 3 2 74LS32D R1 330Ω 5V LED1 Truth Table for OR Gate Input Output 0 0 0 1 1 0 1 1