Uploaded by Mahmoud Sadaka Safia

data sheet - clipin plain SS tiles

advertisement
MATADOR CLIPIN PLAIN STAINLESS STEEL TILES
Type
Matador Clip-in Plain Stainless Steel Ceiling Pans fixed on fully Accessible
Concealed Suspension System
Material
AISI 304 prime cold rolled Stainless Steel sheets polished no 4 finish with 100
micro layer of protective on main side
Texture
Flat smooth surface without blemishes, roller marks, roughness, or stains
Pan Size
600 x 600 mm
Thickness
0.60 mm
Finish
Brush finish
Surface
Pattern
Plain
Edge Detail
Square 90 degree Edge
Elements (%)
Chemical
Composition 304L (18-9L)
C
Si
Mn
0.025 0.40 1.40
Cr
Ni
18.20 8.05
MARCONI METAL INDUSTRIES L.L.C.
www.marconiceilings.com
Page 1 of 4
Corrosion
Resistance
Our grades 304L and 304M generally exhibit a good resistance to wet
corrosion, and are especially recommended when there is a risk of intergranular
corrosion.
They meet the requirements of the standard tests defined by EN ISO 3651-2
(sensitizing treatments T1 and T2). Furthermore they show excellent behavior
in urban and rural atmospheres.
Physical
Properties
Mechanical
Properties
LEED
Credit
Warranty
Ultimate Tensile Strength (UTS) = 630 MPa
Yield Strength (YS) = 300 MPa
Elongation (A) = 54%
Environmentally friendly material with processes contributing
to LEED-NC building requirements
10 Years against any manufacturing defects including corrosion, de-lamination
and blistering. Our warranty covers the ceiling stainless steel panels and
suspension components.
MARCONI METAL INDUSTRIES L.L.C.
www.marconiceilings.com
Page 2 of 4
RIGID SUSPENSION CONCEALED SYSTEM
Standard spring T concealed grid clip-in type rigid suspension system manufactured from high
quality hot dipped galvanised steel sheet; stretcher levelled, with protective coating complying with
ASTM C 635
A.
Tee Spring: Galvanized Steel 0.5mm thick, with
factory-applied protective coating complying with
ASTM C 635, T-sized 29x31mm x 4000mm length
manufactured from hot dipped galvanized steel ASTM
Accessories
A653 not less than Z180 zinc coating
B.
Main Channel: Secondary grid C-shaped 12x38x12mm
x 3000mm length manufactured from 0.5mm hot dipped
galvanized steel ASTM A653 not less than Z180 zinc
coating
C.
Perimeter Edge Trim: Standard Edge Trim of same
metal and finish as per the panel, C-shaped
15x38x15mm x 3000mm length
D.
Cross Connector Clip (Type T): GI Steel 0.90mm
thick x 50mm width x 70mm depth
E.
Rapid Hanger: GI Steel 0.70mm thick x 30mm width x
40mm depth.
Rapid Hangers are used to carry the Main Channels
using the Threaded rods.
MARCONI METAL INDUSTRIES L.L.C.
www.marconiceilings.com
Page 3 of 4
F.
Threaded Rod: M6 rod hanger with 2No. nuts
Threaded Rods are fitted into the Rapid Hangers and
secured by 6mm nuts.
G.
Splice: Joining two Tee Springs when the length is more
than 4mtr, manufactured from hot dipped galvanized
steel complies with ASTM A653 with zinc coating Z180
MARCONI METAL INDUSTRIES L.L.C.
www.marconiceilings.com
Page 4 of 4
Download