Uploaded by Sri ram Mandala

B21EE138L PS2 CRP

advertisement
POWER SYSTEMS 2
CRP
Line to Ground and Line to Line Fault
Analysis in IEEE Standard 9 Bus System
Line to Ground (LG) and Line to Line (LL) faults area unit the 2
most often encountered faults in any power grid network. For
the aim of coming up with advanced protection systems,
detection of the situation likewise because the identification of
the type of fault, from a foreign location is of predominate
importance. during this paper a Discrete riffle remodel based
mostly applied math analysis has been dole out to notice the
fault kind and site of LG and LL faults. IEEE common place
nine bus system has been considered for this purpose. Faults
area unit created to occur within the load buses and outgoing
currents from the generator buses area unit analyzed by
separate riffle remodel (DWT) as these current waveforms
area unit non-stationary in nature. applied math parameters
area unit calculated from the approximate and detail
coefficients that are derived from the DWT. based mostly upon
these parameters, a rule set has additionally been created.
Simulation work is performed with the assistance of MATLAB.
strategies planned here is useful for coming up with higher
protection schemes.
A line to ground fault is associate electrical fault during which
one part of associate AC line is shorted to ground. The fault will
occur either at the generator or the conductor. The fault may be
detected by measure the road currents, line to ground voltages,
and line to line voltages. The IEEE customary nine Bus System
could be a simplified illustration of an influence system used for
B21EE138L
M. SRI RAM
instructional functions. It consists of nine buses connected by
five lines and a couple of transformers. The system is
employed to demonstrate the analysis of line to ground faults.
once a line to ground fault happens, this within the faulted line
is considerably above traditional. this will be wont to notice the
fault and confirm its location. the road current may be
calculated victimization Kirchhoff’s current law; the add of the
currents at a node is up to zero. the road to ground voltage may
be calculated victimization Ohm’s law; the free fall across a
electrical device is up to this through the electrical device times
the resistance. this will be wont to confirm the resistance of
the faulted line. to work out the fault in associate IEEE nine bus
system, the network has to be sculptural victimization the
acceptable facility analysis code. Once the model is
constructed, the fault may be simulated victimization the code.
The fault analysis involves simulating differing kinds of faults
like single line-to-ground (SLG) faults, double line-to-ground
(DLG) faults, and line-to-line (LL) faults. For one line-to-ground
fault, the fault is simulated at the chosen bus and also the
voltage and current values square measure monitored at the
bus. The fault may be cleared by gap the electrical fuse at the
bus. The fault may be cleared by gap the circuit breakers at
each buses. If this doesn't decline, then the fault locations may
be known by watching the magnitude of this at the opposite
buses in the network. A line to ground fault in a very nine bus
system will occur anyplace on the transmission lines.
In the higher than work, LG and LL faults are handled
using DWT primarily based applied math analysis of the
outgoing currents from the generator buses and faults ar
thought of at the load buses. Total six parameters ar
considered-skewness of approximate constant, imbalance of
B21EE138L
M. SRI RAM
detail constant, kurtosis of approximate constant, kurtosis of
detail coefficient, RMS of approximate constant and RMS of
detail constant. IEEE normal nine bus system has been
utilized for this purpose. victimisation the strategy projected
here, type and location of a fault are often discovered by
watching the outgoing currents from the generator buses. gift
work solely considers 2 kinds of faults and fault locations to be
the load buses. However, this work are often extended for
alternative kind of faults occurring at locations aside from load
buses.
B21EE138L
M. SRI RAM
Download