Uploaded by rtwong

BRAKE HOSE SPI

advertisement
HOSE TAPING:
1. To load tape: insert into roller with tape unraveling from bottom with sticky side up
2. Lift roller latch
3. Pull tape and wrap around rollers
4. Lower roller latch
5. Make sure psi is set to 30-40 psi
6. Place bundled cable firmly into the jaws
7. If tape is loose or is not taping correctly adjust psi accordingly
HOSE STUFFING:
1. Before start: place ink cartridge upside down for 3-5 hours or until you see the pad is saturated
with white ink
2. Remove lid and place cartridge in the rear with rubber clamp
3.
4.
5.
6.
Make sure psi is set to 60-80 PSI
Insert hose until it clicks
Make sure paint is visible
When finished, remove ink cartridge from the rear and replace lid for storage
DO NOT LEAVE INK CARTDRIDGE INSERTED WHEN FINISHED
DO NOT ADJUST LENGTH UNLESS DONE BY ENGINEER
Download