SRM INSTITUTE OF SCIENCE AND TECHNOLOGY, DEPARTMENT OF ELECTRICAL AND ELECTRONICS ENGINEERING 18CSS201J: ANALOG AND DIGITAL ELECTRONICS UNIVERSITY PRACTICAL EXAM GENERAL INSTRUCTIONS Dear Students, 1. Check the university lab schedule and reach the venue 15 minutes before the commencement of exam. 2. Student should randomly pickup one question paper among the papers kept on the table. 3. As per examiner’s direction, occupy the system / place in the lab 4. Refer to the mark split-up and start writing the content (Aim, design, circuit diagram / logic diagram, k map, Formula, Procedure, Model graph, etc.,) 5. After completing all writing part approach the examiner for verification and wait for his approval to turn on the system / student laptop. 6. Students should use https://www.multisim.com/create/ for performing the normal experiments, for D FF based experiment: https://tinyurl.com/yckvx83u and for JK FF based experiment: https://tinyurl.com/mr2fbfud 7. After completing the simulation / hardware experiment, get the attestation from the examiner. 8. Don’t use the saved experiment / any shared link from friends. 9. Don’t save the file before showing the output to the examiner. Any students using the saved experiment will be treated as malpractice. 10. Mark split for analog experiment Aim 2 Circuit diagram, Tabulation, Formula, Procedure & 10 Model graph Execution & Result 8 Viva 5 TOTAL 25 11. Mark split for digital experiment Aim 2 Circuit diagram / Logic diagram, Tabulation, Formula 10 / K map simplification, Procedure & Timing diagram Execution & Result 8 Viva 5 TOTAL 25 ***All the Best***