Third Row Seat Removal and Installation
1. Third Row Seat Cushion Cover/Pad ­ Remove
1. Remove the foot covers (A) and bolts.
2. Remove the bolt and seat cushion cover/pad (A).
2. Cargo Areas Interior Trim ­ Remove
3. Third Row Seat Back ­ Remove
1. Remove the bolts.
NOTE: The illustration shows a left rear seat. Do the same
procedure for the right rear seat.
2. Fold down left seat back (A).
3. Remove the bolts and third row seat back.
4. All Removed Parts ­ Install
1. Install the parts in the reverse order of removal.
NOTE: Make sure that the left and right third row seat belts are routed correctly after installation of the third row seat by using
the inspection method below.
‐1. Compare the stitching on the third row seat belt with the edge of the rear side trim panel arm rest.
If the third row seat belt stitching lines up with the edge of the rear side trim panel arm rest as shown, the third row
seat belt is Good.
If the third row seat belt stitching does not line up with the edge of the rear side trim panel arm rest, the third row seat
belt is not routed properly. Go to step 2.
‐2. Remove the divider cargo bin.
‐3. While pulling up on the third row seat belt, maneuver the third row seat belt from beneath the third row seat outer recline
cover to release the belt.
‐4. Go to step 1 again.
Front View
Rear View