IMMULITE and IMMULITE 1000
‘The Cabling Map’
The Main Power Supply
Harness ‘P3’
dedicated to the PMT
&
Main. Circulation Fan
Harness ‘P1’
Motor Driver #1
PCB
Harness ‘P2’
Communication
Motherboard #1 PCB
Motor / Heater
PCB
Motherboard #2 PCB
Motor Driver #2
PCB
PMT Signals
Pipettor- X
Pipettor- Z
Reagent Car.
Luminometer
Chain
Sample/Assay
Barcode Reader Motor
High-Speed
Spinner Motor
Reagent Temp Signal
Water & Substrate
Wash Pumps
Mod. Intrfc. PCB
CPU / Sensor
PCB
Misc. Logic Sigs., via Mothr. #2
Luminometer Module Interface PCB
Reagent Module Interface PCB
Temperatures
System Amb. Temp Signal
Mn.Inc.Car.
Syringe Fluid
Valves
All PC
Communications,
through Mother
PCB #2
Tube Shuttle
PMT
Attenuator
Substrate Htr. Logic Sigs.
High Speed Spinner
Feedback
Drive
Display Panel
- through
Mother PCB #2
All Barcode
Signals Recvd.
- through
Mother PCB #2
Incubator Temp Signal
Luminometer Temp
Signal
Drivers for
Heaters & TED
Mod. Intrfc. PCB
RS232 Cable
to the Computer
Load Chain
‘The Front End’
(Also Includes the Syringes)
<They work from their
own Logic/Driver PCBs>
‘The Rear End’
Substrate
Pre-Heater
-‘Blue’ wire is Driver to ‘J10’ of
Syringe Intrfc. PCB, fr. Mtr./Htr. PCB.
-‘Yellow’ wire is Logic Comm. to CPU
PCB, thru ‘pin 9’ of Lum. Intrfc. PCB.
Water &
Probe-Wash
Bottle Sensors
*(IMM 1000
only)
Sample Collection
Tray Full/In-Place
Sensors – through
Mother PCB #2
All Motor
Position OptoSensor Signals
Recvd. -through
Mother PCB #2
- (All Colored
Flat Ribbon
Comm. Cables
from each
module’s intrfc.
PCB)