Sheet 2 Dr. Lobna A. Said Problem 1: Find the total power developed in the circuit in Fig. 1 if 𝑣0 = 5 V. Fig.1 Problem 2: The circuit shown in Fig.2 contains a dependent source. Determine the value of the gain k of that dependent source. Fig.2 Problem 3: The values of the current and voltage of each circuit element are shown in Fig. 3. Determine the values of the resistance R and of the gain of the dependent source A. Fig.3 1 Sheet 2 Dr. Lobna A. Said Problem 4: Find and the power absorbed by each element in the circuit of Fig. 4 Problem 5: Determine the number of branches and nodes in the circuit of Fig. 5. Fig.5 2 Sheet 2 Dr. Lobna A. Said Problem 6: The current 𝑖𝑥 in the circuit shown in Fig. 6 is 50 mA and the voltage 𝑣𝑥 is 3.5 V. Find (a) 𝑖1 ,(b) 𝑣1 ; (c) 𝑣𝑔 ; and (d) the power supplied by the voltage source Problem 7: Fig.6 Find 𝐼 and the power absorbed byeach element in the network of Fig. 7. Problem 8: Fig.7 Determine the power received by each of the resistors in the circuit shown below. 3 Sheet 2 Dr. Lobna A. Said Problem 9: Find 𝑉𝑎𝑏 for each circuit in Fig. 10 (a) (b) (c) (d) Fig.10 Problem 10: For the circuit shown below, find (a) 𝑖1 ,(b) 𝑖2 ; (c) 𝑣0 ;(d) Verify that the total power developed equals the total power dissipated. Problem 11: Determine the value of voltage v in the circuit shown below 4 Sheet 2 Dr. Lobna A. Said Problem 12: The currents 𝑖1 and 𝑖2 in the circuit in below are 21 𝐴 and 14 𝐴, respectively. a) Find the power supplied by each voltage source. b) Show that the total power supplied equals the total power dissipated in the resistors. Problem 13: Obtain 𝑣1 through 𝑣3 in the circuit below. Problem 14: The variable resistor R in the circuit below , is adjusted until 𝑣𝑎 = 60 V Find the value of R. 5