Taxi light is used to illuminate taxiways or obstacles on either side of the aircraft *Runway
turnoff lights
2 points
True
False
Direct current is used on systems that must be compatible with battery power, such as on light
aircraft and automobiles *
2 points
True
False
Cabin lighting system illuminates the cabin, the entrances, the lavatories, the galley and the
attendant work areas. *
2 points
True
False
The lower area in the upper ECAM is used to display TAT& SAT, clock and Gross
Weight *lower ECAM
2 points
True
False
Starter contactor is a device used to power the propeller *
2 points
True
False
A limit switch is an electromechanical device that consists of an actuator mechanically linked
to a set of contacts *
2 points
True
False
The advisory mode is automatically presented when warning/caution is triggered *failure mode
2 points
True
False
The purpose of CVR is to collect and record data from a variety of aircraft sensors *Flight
Voice Recorder (FRD)
2 points
True
False
These electrons are attracted to the negative terminal of the battery * positive
2 points
True
False
BITE memorizes all the information concerning aircraft failures *
2 points
True
False
Logo lights are generally mounted on the upper surface of the vertical stabilizer and are aimed
to illuminate the Company markings on the tail of the aircraft *horizontal
2 points
True
False
The maintenance post flight report can be printed on ground *
2 points
True
False
EFIS uses two display in the center to give flight parameters and navigational data *
2 points
True
False
Solid State Cockpit Voice Recorder are capable of recording for a period of 2 hours *
2 points
True
False
In C-127 the location of battery is located at the center firewall *C172
2 points
True
False
APU generator can supply the entire electrical network if no other power sources are
available *
2 points
True
False
Attendant work lights are installed at each attendant station *
2 points
True
False
Full discharge is not harmful to a lead acid batteries *nickel cadmium
2 points
True
False
The greater the circuit resistance, the less the current *
2 points
True
False
MCDU will display the fault and may also display the appropriate steps of the remedial action. *ECAM
2 points
True
False