Baseband digital modulation: Miller code
THIS ARTICLE BUILDS UPON THE → INTRODUCTORY ARTICLE ABOUT BASEBAND MODULATION WHERE MANCHESTER
code was explained, and hopefully understood and accepted by the reader as a viable
code.
There are many, many "simple" codes. By "simple", I mean a code that can be
implemented by a simple hardware circuit. More sophisticated codes like "m-to-n"
and chirp codes are product of recent technology advancements.
Among the simple codes, one of the most e cient and beautiful is Miller code. It
belongs to the group of delay codes, since they signal a bit by a delay in the transition
from low to high or vice-versa.
The rules of Miller code are:
If bit is 0, do not invert the signal.
If bit is 0 but previous bit was also 0, invert the signal at the edge of the bit.
If bit is 1, invert the signal at the middle of the bit (this is the delayed transition).
0
0
0
0
1
1
0
1
Original message
Message encoded with Miller code
As can be realized visually, the Miller waveform has few transitions. This characteristic
saves bandwidth. Miller spectrum is better even than the original NRZ message; most
energy is concentrated in the middle of spectrum (e.g. 600Hz for a 1200bps stream),
and almost no DC bias.
Miller code is also "di erential out-of-the box", immune to polarity inversion, since
the message bits are naturally encoded in terms of inversions (or transitions), not in
terms of absolute levels.
A very interesting characteristic of Miller code is the relationship with Manchester
code. A Miller stream can be derived from Manchester just "dividing it by two", that is,
by discarding every other transition in Manchester waveform.
0
0
0
0
1
1
0
1
Original message
Manchester code (inverted version)
Miller code
So, at least for the TX side, the Miller encoder has an obvious implementation: a
Manchester encoder followed by a ip- op.
To decode Miller, the RX side can pay attention to the relative lengths of each
transition (1x, 1.5x and 2x). The common denominator is the data rate, so it does not
have to be agreed upon in advance.
In particular, the longest transition (2x) can only happen when the bit sequence is
"101", and its edges fall in the middle of "1" bits. Given this fact, it is easy to recover
the clock.
0 Comments
Sort by Oldest
Add a comment...
Facebook Comments Plugin
Follow @epx__
This is → Elvis Pfützenreuter's personal site
Este é o site pessoal de → Elvis Pfützenreuter