MATERIAL SAFETY DATA SHEET
Introductory Information
Product Name: Orithane RG 4630
Page: 1 of 4
SECTION 1: CHEMICAL PRODUCT AND COMPANY IDENTIFICATION
1.1 Product Details
Product Name
Trade Name
Chemical Name
Application
:
:
:
:
Orithane RG 4630
Orithane RG 4630
Compounded Polyol blend
Use together with polymeric MDI to produce rigid polyurethane
foam.
1.2 Company Identification
Name and Address
Telephone Number
Facsimile Number
: Oriken Polyurethanes Sdn Bhd
Unit 1009, Block B, Phileo Damansara II
#15 Jalan 16/11, Off Jalan Damansara
46350 Petaling Jaya
Selangor Darul Ehsan, Malaysia.
: +603 7957 0633
: +603 7957 8533
SECTION 2: HAZARDS IDENTIFICATION
Consideration of the composition of this product indicates that it does not present a significant health
hazard to users.
SECTION 3: COMPOSITION / INFORMATION ON INGREDIENTS
Chemical Name
Tris(2-chloro-1-methylethyl)phosphate
CAS No.
13674-84-5
Proportion
12.5-15%
Polyether Polyol
HCFC 141b
Amine Catalyst
9003-11-6
001717-00-6
9894-2
20-30%
< 20%
1–3
SECTION 4: FIRST AID MEASURES
Eye contact
Skin contact
Inhalation
Ingestion
: Irrigate with eyewash solution or clean water. Obtain immediate
medical attention.
: Wash immediately with water followed by soap and water.
: Remove patient from exposure.
: Provided the patient is conscious, wash out mouth with water and
give 200 - 300 ml (half a pint) of water to drink. Do not induce
vomiting.
Prepared by: Oriken Polyurethanes Sdn Bhd
MATERIAL SAFETY DATA SHEET
Introductory Information
Product Name: Orithane RG 4630
Page: 2 of 4
SECTION 5: FIRE FIGHTHING MEASURES
Not classified as flammable.
Extinguishing Media
Fire Fighting Protective Equipment
: Normal extinguishing media.
: Full protective equipment including suitable respiratory
protection.
SECTION 6: ACCIDENTAL RELEASE MEASURES
Caution - spillages may be slippery.
Absorb spillages onto sand, earth or any suitable absorbent material.
Transfer to a container for disposal.
Wash the spillage area clean with water and detergent.
Do not allow spillage to enter drain, sewer or water source.
SECTION 7: HANDLING AND STORAGE
Handling
Storage
: Keep away from heat and sources of ignition. Care should be taken to release any
internal pressure slowly. Take precautionary measures against static discharges.
: Keep in cool, well-ventilated place away from direct sunlight. Keep containers
properly sealed when not in use.
SECTION 8: EXPOSURE CONTROL AND PERSONAL PROTECTION
Precautionary measures:
Give adequate ventilation to the premises where the product is stored and/or handled.
Respiratory protection:
Not needed for normal use.
Protection for hands:
Use protective gloves.
Eye protection:
Safety goggles.
Protection for skin:
Use clothing that provides comprehensive protection to the skin.
Exposure Limits
LTEL 8HR TWA
STEL
Notes
Prepared by: Oriken Polyurethanes Sdn Bhd
MATERIAL SAFETY DATA SHEET
Introductory Information
Product Name: Orithane RG 4630
Page: 3 of 4
SECTION 9: PHYSICAL AND CHEMICAL PROPERTIES
Appearance
Viscosity
Boiling Point (Deg C)
Flash Point (Deg C)
Explosive limits
Vapor Pressure
:
:
:
:
:
:
Yellowish liquid
~ 2500m.Pa at 20°C
Not applicable
Not applicable.
Not applicable.
Not applicable
SECTION 10: STABILITY AND REACTIVITY
Conditions to avoid
Substances to avoid
Hazardous Decomposition Product (s)
: Stable under normal conditions.
: None in particular.
: None at ambient temperature.
SECTION 11: TOXICOLOGICAL INFORMATION
The concentration of each substance should be borne in mind in accessing the toxological effects
deriving from the preparation.
Set out below is the toxological information relating to the main substances in the preparation:
Tris(2-chloro-1-methylethy)phosphate
Inhalation
: LC50 rat > 7.19 mg/l.
Ingestion
: LD50 rat > 2000mg/kg.
Dermal toxicity : LD50 rat > 2000mg/kg.
Skin/eye contact : not classified as an irritant.
Mutagenicity
: negative test.
Carcinogenecity : no data available.
SECTION 12: ECOLOGICAL INFORMATION
Environmental Pets and Distribution
No information available.
Toxicity
No data.
Effect on Effluent Treatment
No data.
SECTION 13: DISPOSAL INFORMATION
The generation of waste should be avoided or minimized wherever possible.
Disposal should be in accordance with local, state or national legislation.
Waste, even small quantities, should never be poured down drains, sewers or water sources.
Prepared by: Oriken Polyurethanes Sdn Bhd
MATERIAL SAFETY DATA SHEET
Introductory Information
Product Name: Orithane RG 4630
Page: 4 of 4
SECTION 14: TRANSPORTATION INFORMATION
Road (ADR)
Air (ICAO/IATA)
Sea (IMDG/IMO)
: Not regulated.
: Not regulated.
: Not regulated.
SECTION 15: REGULATORY INFORMATION
Not Classified as Dangerous for Supply/Use.
EC Classification
Hazard symbol
Risk phrase
Safety phrase
: Not Classified
: None required
: None required
: None required
SECTION 16: Other Information
Issue Date
Revision Date
Disclaimer
: 10 January 2015
: 22 January 2018
: Terms and Conditions: This SDS is designed only as guidance for the
products to which it applies. The information contain herein is based on the
manufacturer’s own study and the work of others, nevertheless, it does not
constitute a guarantee for any specific product features and does not establish
any legally binding contract.
ADR
IMDG
ICAO
IATA
GHS
: European agreement on International carriage of dangerous goods by rail/road
: International Maritime Dangerous Goods code
: International Civil Aviation Organisation
: International Air Transport Association
: Globally Harmonized System of Classification and Labelling of Chemicals.
Prepared by: Oriken Polyurethanes Sdn Bhd