All Engineers, Kindly share all installation snaps as 1. 2. 3. 4. 5. 6. 7. 8. 9. 10. 11. 12. 13. 14. 15. 16. 17. 18. 19. 20. 21. 22. 23. 24. 25. Material Receiving Snaps with Serial Number System Module (FSMF/AMIA/ASIA/ABIA) Serial Number Clear Snaps All RF Module Serial Number Clear Snaps All Antennas Make & Model Number Clear Snaps Write all on the Paper & send Snaps a) Serial No. of System Module, RF Module and Antenna Make & Model No. a) Antenna Azimuth b) Antenna Mounting Height c) Total Port of Antenna & Total used port d) Antenna Mechanical & Electrical Tilt Site ON Air Snaps System Module/AirScale Installation Snaps (Open & Closed View) System Module/AirScale Installation (All Cabling termination from Front) RF Module Installation (Sector-1, Sector-2, Sector-3 and Sector-4) All RF Module Installation (All Cabling termination from Front) ODF Installation (All Cabling termination from inside and Front) System Module/AirScale Power Cable Routing and Termination at DCDB/PP End RF Module Power Cable Routing and Termination at DCDB/PP end OBSAI/CIPRI Cable routing (FSM end; RFM End and in Between FSM and RFM) Power Cable Routing for all Modules OVP Installation and Terminations Jumper Cable routing and terminations at Antenna end Weather Proofing Snaps Antenna Installation (Sector-1, Sector-2, Sector-3 and Sector-4) Labelling (All Cables) RET Cable installation termination EAC Alarm cable and DDF installation All IP Seal and IP Boots Site Clean Complete Site View Note:- Don’t miss any above snaps