NACE-CIP1-001 dumps
Coating Inspector Level 1
CIP Level 1 NACE-CIP1-001 Practice Questions
1. You are the NACE Inspector on a tank lining project where a 50% solids epoxy tank
lining is being applied. After application of the 19 coat you notice small blisters in
some areas of the applied lining.
Your FIRST preferred course of action is to:
A. Break the blisters to see what's inside
B. Document the problem and advise the Contractor and Owner's representative
C. Document the problem and advise the Contractor
D. Extract any liquid that may be inside the blister and send it to the lab for further
analysis
Answer: B
Passcert.com
CIP Level 1 NACE-CIP1-001 Practice Questions
2. Dew point is the temperature at which
A. water freezes.
B. humidity decreases
C. condensation occurs.
D. the air is saturated.
Answer: C
Passcert.com
CIP Level 1 NACE-CIP1-001 Practice Questions
3. If a contractor is using a poorly maintained compressor to supply air for abrasive
blast cleaning and conventional airspray, the coating inspector should perform a
A. dry film thickness (DEI) measurement.
B. wet film thickness (WFT) measurement.
C. blotter test for the presence of oil and water.
D. vial lest.
Answer: C
Passcert.com
CIP Level 1 NACE-CIP1-001 Practice Questions
4. Upon arrival of coating materials, the inspector should
A. review coating contractors' plans for storage of coating materials and confirm they
meet national, local and owners' fire and environmental regulations.
B. observe and document the amount of material and batch numbers.
C. observe aryl document that the applicator WFT at regular intervals during
application.
D. observe and document time frame and environmental conditions between each
coat.
Answer: B
Passcert.com
CIP Level 1 NACE-CIP1-001 Practice Questions
5. Relative humidity is
A. a measure of the amount of moisture in the air compared to saturation level.
B. a measure of the amount of moisture in the air compared to the air temperature.
C. the lowest temperature at which moisture forms on a steel surface.
D. the highest temperature at which moisture forms on a steel surface.
Answer: A
Passcert.com
CIP Level 1 NACE-CIP1-001 Practice Questions
6. Galvanic corrosion occurs on which of the following substrates:
A. Concrete
B. Fiberglass Reinforced Plastic
C. Metal
D. Wood
Answer: C
Passcert.com
CIP Level 1 NACE-CIP1-001 Practice Questions
7. When applying Thermal Spray Coatings the specification is most likely to refence:
A. SSPC PA 2
B. NACE SP 0178
C. NACE SP 0188
D. SSPC-CS 23.00/AWS C2.23/NACE No. 12
Answer: D
Passcert.com
CIP Level 1 NACE-CIP1-001 Practice Questions
8. What is the minimum recommended distance away from an edge that an inspector
should take a measurement with a dial-type magnetic pull-off Dry Film Thickness
(DFT) gauge?
A. 1 cm (.39 inch)
B. 2.5 cm (1 inch)
C. 6.35 cm (2.5 inch)
D. 2.5 millimeters (.10 inch)
Answer: B
Passcert.com
Why choose Passcert dumps?
1.
2.
3.
4.
5.
Questions collected from real test
One year free update
Money back guarantee
Send both pdf and software(free)
Lower price
https://www.passcert.com/NACE-CIP1-001.html