Uploaded by Denroy Durant

SPILLAGE PROCEDURE 1

advertisement
SPILLAGE PROCEDURE
In the portable sanitation industry, because of the relatively safe nature of chemical
products involved, it is unlikely that a serious environmental issue will occur. Basic care
and attention regarding the storage of chemical containers on the vehicle, correct
handling of product and checking of vacuum hoses and plant will go a long way to
prevent spillage of chemicals or effluent.
Checklist for avoiding spillage
Pump Truck
1. Before leaving the yard check all hoses for fractures and damage replace hoses
and connection fittings immediately where necessary
2. Make sure all valves and outlets on the vehicle effluent tank are secure
3. Ensure that all chemical containers are tightly sealed and stowed securely in an
upright position to avoid becoming detached from the vehicle whilst negotiating
rough terrain
4. Make sure that there is adequate spare capacity within the effluent tank for the
day’s workload
5. On site do not be hasty to turn off the vacuum pump when pumping out a toilet
unit as this can give rise to effluent running back down the vacuum hose onto the
ground, causing site Contamination
6. Before leaving the site make sure that all containers are stowed securely on the
vehicle
7. In the case of contamination a result of a toilet being pushed over on site, please
make sure your office and the site operator are advised and a correct (witnessed
if possible) written record of the event be made prior to attempting to clean up the
contamination
8. It is advisable to remove a heavily contaminated toilet from site and replace it
with a clean unit rather than risk further contamination attempting extensive
cleaning down on site.
9. If it is not possible to remove the unit immediately from site, make sure access to
the toilet is denied by means of locking the unit, a secure binding, or place a
barrier around the unit.
10. Place a notice of contamination on the toilet to prevent further access by site
workers or members of the public.
11. Prior to transporting any contaminated toilet unit, ensure that no effluent or other
contaminants can leak from the unit. If necessary bind securely with strong
plastic sheeting to contain any possible leaks.
12. Once the contaminated toilet has been removed, clean up any other
contaminants using a spillage kit and remove from site for secure disposal.
PORTABLE TOILET SERVICING AND
MAINTENANCE PROCEDURES
1
.
Servicing
.
The servicing of portable toilets is a method of maintaining hygiene standards for the
ongoing use of portable
toilets. The industry standard for Site Toilets is to service on a weekly basis,
the toilet being provided for the use of up to 7 persons over a 7 day cycle between
services. The
main purpose of servicing is to provide for the following:
1
.1
1
.2
1
.3
1.4
1.5
1.6
To remove all effluent from the toilet tank for secure disposal.
To flush through and remove all contaminants from the pump and filter unit.
To sanitise the toilet tank removing all traces of bacterial deposits.
To cleanse the toilet unit inside a
nd out to an acceptable condition.
To provide consumables including toilet additive, toilet rolls, paper towels hand soap
and
hand washing water as required.
To check on the general condition of the unit replacing damaged parts as necessary.
2
.
Operators
Personal Protective Equipment
. PPE must be worn whilst servicing Portable toilets. The
following is provided for the operator:
2
.1
2
.2
2
.3
2.4
2.5
2.6
2.7
2.8
2.9
Heavy duty waterproof and chemical resistant gloves or gauntlets.
High visibility jacket
or vest.
Washable or waterproof work trousers.
Heavy duty work boots with toe reinforcement.
Eye protection
goggles or visor.
Disposable Particle masks.
Hard hat.
Change of dry working clothes.
Provision of an alcohol based hand steriliser or mobile wash
station on the vehicle.
3.
Chemical Hazard Identification
. In the Portable Sanitation industry most Chemical products used
are classified as low hazard. It is unlikely that serious injury will be sustained from use
of these
products if used in accordanc
e with the manufacturer’s instructions.
COSHH data is provided by the manufacturer on all Chemicals. Operators must be
aware of any
hazards prior to use and provided with access to all COSHH data on request. Operators
are
advised of the following general
good practices when dealing with toilet waste and chemicals
used in servicing as follows:
3.1
3.2
3.3
3.4
Skin contact
. Do not allow any chemicals or effluent to come into contact with skin. It is
particularly important to keep any
open wounds well protected. Wear protective gloves.
Avoid splashing onto the face or forearms.
Eye contact
. Avoid all eye contact with Chemicals. Check COSHH data on individual
products, but generally most chemicals will cause irritation of the eye.
Inges
tion
. Do not ingest any chemical or effluent. Nausea and stomach pain may follow
accidental ingestion, but please check COSHH data for information on individual
products
prior
to seeking medical attention.
Inhalation
. Avoid inhalation of all chemical fume
s. Some Chemicals will cause congestion of
the lungs and tightness of the chest. Any operator prone to Asthma should seek further
medical advice. Check COSHH data for information on products
.
Download