SwivelMount™ Universal Speaker Wall Mounting Bracket SM-010 Installation Instructions Installation Preparation: The SwivelMount™ bracket mounts most speakers and other objects weighing up to a maximum of 10 lbs. to walls and ceilings and provides a swivel option for better aiming . Read these instructions carefully before installing and check that you have all of the following items: Item 1. 2. 3. Qty 2 pcs. 4 pcs. 4 pcs. Description Swivel Mount bracket Screw, M5x8, Silver Machine screw - 1/4-20 x 1/2" long Item 4. 5. Qty 4 pcs. 1 pcs Description Star washer, 1/4" diameter Instruction Sheet Step 1. Fastening to Wall Decide on the mounting location. Be sure there is adequate structural material for mounting, such as a stud. Do not rely on drywall, acoustic tiles, etc. to support the weight of the speaker. Use the SwivelMount™ as a template to mark the center of the four keyholes. Select a #10 or 3/16" diameter fastener that fits through the keyhole (consult a hardware specialist for the proper fastening method). Loosely install the fasteners so the SwivelMount™ can be attached to the wall later. Step 2. Mounting Speaker to Bracket Place the curved slots of the SwivelMount™ over the speaker's mounting holes in the base of the speaker. If screws are supplied with the speaker, use them to attach the speaker through the curved slots of the SwivelMount™. If not, use the 1/4-20 x 1/2" screws (domestic speakers) or M5x8 metric screws (imported speakers) included. If these are not the proper hardware for your speaker, consult a hardware specialist for the proper fastener (See Figure 2). Step 3. Mounting holes in speaker not provided: Figure 1: Assembly View Check with the speaker manufacturer for proper mounting instructions. Figure 1: Assembly View Step 4. Attaching the Swivel Mount ™ to the Wall: Place the Swivel Mount's keyholes over the fasteners in the wall. Be sure the fasteners lock into the neck of the keyhole then secure but do not over tighten. Swivel the speaker to the optimum angle and tighten all screws securely, ( See Figure 2). Step 5. Recommendation: Install Safety Cable Attach a safety cable (sold separately) to the mounting surface then attach the other end of the safety cable to the speaker. If no attachment is provided on speaker, consult speaker manufacturer for advice on best attachment point and method. Important Note: Do not exceed the weight load of ten Pounds ( 10 lbs ). Anchor the Swivel Mount into a solid structural material such as a wall stud. Allen Products Company Inc. 1635 E. Burnett Street Signal Hil , CA 90755 USA Tel: (562) 424-1100 Fax: (562) 424-3520 Web Page: www.allenproducts.com Rev. 03 . Figure 2: Lower View Swivel speaker into position then fully Tigthen screws to secure speaker 10/04/04