DDBC120-DALI
DALI Multi Master Controller
The DDBC120-DALI is designed for cost-effective control of DALI high frequency fluorescent ballasts, providing a
full universe of 64 DALI address & communication to Philips Dynalite DALI user interfaces. Direct DALI to DyNet
mapping means that the DALI-imposed limits, such as the maximum of 16 groups, are seamlessly overcome allowing
for a fully scalable network solution. This leverages the advantages of a true DALI network whilst still allowing and
the full function set of Dynet. This device is DIN rail mountable, designed to be installed in a switchboard, that is
supplying power to the controlled lighting circuit. The DDBC120-DALI contains an integral DALI bus power supply,
removing the need for the provision of a separate external supply which reduces switch board wiring complexities.
technical data
Supply
100 -240V 50/60Hz Single Phase at
0.25A
Output Terminals
1 x DALI Ballast circuit: DA-, DA+
1 x 1.5mm2 max conductor size
Control Outputs
1 x DALI control output, supporting
one full DALI universe of 64 address,
including backward channel &
communication to Philips Dynalite DALI
user interfaces
Diagnostic Functions*
Lamp failure reporting
Ballast failure reporting
Emergency test reporting
Ballast run time tracking for each ballast
Device Online/Offline status
Control Inputs
1 x RS485 DyNet serial port
1 x AUX programmable dry contact input
DALI Bus Power Supply
Inbuilt rated 220mA @ 16VDC Typical
(64 ballast & 10 User Interfaces.)
Current unit MAX 250mA
Power relay
1 x Feed through switched circuit rated
at 20A (500A surge) for supply to lighting
ballast.
User Controls
Service Switch
Diagnostic LED
*EnvisionManager interface is required for
analysing diagnostic data. The availability of some
diagnostics is dependent on the ballast type.
Operating Environment
0˚ to 40˚C ambient temperature
0% to 90% RH non-condensing
Compliance
CE, C-Tick, IEC62386
Enclosure
Polycarbonate DIN Rail enclosure (6 unit)
Dimensions
H 94.5mm x W 105mm x D 75mm
Weight
Packed weight 0.35kg
DyNet DC Supply
120mA (Approximately 6 panels)
Preset Scenes
170
DALI Insulation System
Basic
Supply Terminals
Line, Neutral, Earth
1 x 4mm2 max conductor size
load compatibility
DALI high frequency fluorescent ballasts
DALI electronic low-voltage transformers
DALI LED fixtures
DALI Emergency fixtures
Philips Dynalite DALI UI devices
DDBC120-DALI
HF Ballast Controller
electrical diagram
mounting dimensions
105
94.5
59
38
51
75
69
46
For further information contact:
t +61 2 8338 9899 • f +61 2 8338 9333
dynalite-online.com • dynalite.info@philips.com
DDBC120-DALI Data Sheet Rev D July 2012
Specifications subject to change without notice. © WMGD Pty Ltd Trading as Philips
Dynalite. Unit 6, 691 Gardeners Road Mascot 2020 Australia. ABN 33 097 246 921. All rights
reserved. Dynalite, DyNet and associated logos are the registered trademarks of Dynalite
WMGD Pty Ltd. Not to be reproduced without permission.