INSTALLATION INSTRUCTIONS FOR SKU#9386587/9386588 (94377A-BO/94377A-BO-DIS)
IMPORTANT SAFETY INSTRUCTIONS
 Before starting the installation, shut off the power supply at the electrical panel by switching
off the circuit breaker or removing the appropriate fuse. Cutting the power at the light
switch is not sufficient to prevent electrical shock.
 This unit is suitable for installation in a dry, indoor location only.
Electrical connections:
 We strongly recommend that this ceiling lamp be installed by a licensed electrician.
Tools and materials required (not included):
Adjustable wrench, flathead screwdriver, wire cutters, stepladder.
ASSEMBLY INSTRUCTIONS
1. Shut off the power supply at the electrical panel by switching off the circuit breaker or
removing the appropriate fuse.
2. Carefully unpack all the lamp parts and hardware and lay them on a clean work surface.
3. The height of this lamp is adjustable. If you wish to change the height, please see Fig. 1.
4. While holding the glass shade “J” over the lamp holder “G”, align the holes in the glass shade
with the holes in the lamp holder and secure with the 3 support sticks “H”. Revolve the metal
frame if you wish to adjust its angle.
5. Insert 1 standard Type A bulb “I”, maximum 60W (not included).
6. Take the mounting plate “C” and mount it to the ceiling junction box “A” with the junction
box screws “D”. Tighten the screws with a screwdriver. The side of the mounting plate
marked “GND” must face down.
7. Gently pull the wiring down from the ceiling junction box and allow it to hang.
8. While holding the lamp holder toward the ceiling, carefully inspect the wires of the ceiling
lamp and of the ceiling junction box. Usually, the colour of the “hot” (positive) wire is black,
the neutral wire is white and the ground wire is green.
9. Attach the hot wire (black colour and marked “L” on the wire) of the ceiling lamp to the
black hot wire of the junction box. Attach them together with a wire cap “B”.
10. Attach the neutral wire (white colour and marked “N” on the wire) of the ceiling lamp to the
white neutral wire of the junction box. Attach them together with a wire cap “B”.
11. Attach the ground wire (green colour and marked “G” on the wire) and the copper ground
wire of the pendant lamp to the ground wire of the junction box. Attach them together with
a wire cap “B”.
12. Do not reverse the hot and neutral connections or safety will be compromised.
13. Lock the canopy in place by threading the cap nut “F” onto the screw of the mounting
plate.
14. Restore power to the junction box and test the fixture.
15. This ceiling lamp can be used with a dimmer switch.
16. The minimum distance between the canopy and lampshade must be 4 inches (100mm).
Parts list:
A． Ceiling junction box
B． Wire caps
C． Mounting plate
D． Junction box screws
E． Canopy
F． Cap nut
G． Lamp holder
H． Support stick
I. Bulb (not included)
J. Glass shade
NOTE : “neutral wire” not “Nautral Wire”, “ground wire” not “Ground Wire” and “live wire” not
“Live Wire”