EGM 180 Kit Agreement Organizer Box total actual BOE Bot Hardware 1" standoffs 1/4" panhead screws 3/8" panhead screws 3/8" flathead screws nuts Small Black Wheel Screws 4 8 10 2 10 2 Sensors IR Detectors QTI QTI Wires Speakers Sonar 2 2 2 1 1 Resistors 10 kOhm 1 kOhm 2 kOhm 220 Ohm resistor 470 Ohm resistor 4.7 kOhm resistor Photoresistors 2 2 2 8 4 2 2 Capacitors .01 microFerad .1 microFerad 2 2 LEDs Infrared LED Red LED LED cover 2 2 2 Square Bot Chassis Bearing flat partially threaded beams (2") keps nut 8-32 hex screw (1/4") 8-32 hex screw (1/2") 36 tooth gear collar with threaded set screw square bar (2") square bar (3") 6-32 hex screw (1/2") Clutch Clutch Shaft total TOOLS 12 4 38 26 20 4 10 2 4 4 3 3 Small Allen Wrench Bigger Allen Wrench Screw Driver Crescent Wrench 1 1 1 1 actual Big Gray Box Organizer Box total actual 1 Vex Hardware panel chassis rail chassis bumper Vex Wheel/Tire 60 tooth gear Vex Servos Vex Motors 1 4 2 4 2 1 2 BOE Bot Hardware Battery Pack Board of Education Chassis Wheels Rubberband Tires Continuous Rotation Servo 1 1 1 2 2 2 Remote Control 1 I agree that the EGM 180 parts kit issued to my team at the start of the Spring 2011 semester contains the parts indicated above. I further agree that my team will be responsible for the replacement costs of any parts listed above that are not returned in good working condition at the end of the semester. The replacement costs for missing or damaged parts will be distributed equally among all members of my team and will be billed to each team member’s UNC Asheville tuition and fees account. Indicate your agreement by both printing and signing your name below. Team member 1: ____________________________________________________________ Team member 2: ____________________________________________________________ Team member 3: _____________________________________________________________