Name: __________________________ ID Number: ___________________ Class: ___________
Open the file BridgeRectifierWFilter.ms10
.
1. Analyze the circuit using your rectifier theory.
2. Draw the expected output of the filter labeling each significant point.
3. Run the simulations and compare your results to step 2.
© 2007 National Instruments Corporation. Permission is granted to duplicate this page for classroom use.

4. Open the file Zener.ms10
.
5. Given that Vz = 10 V, check to see whether each zener is operating above or below the knee.
Vo1 =
Vo2 =
6. Replace the parallel resistor in part B with a 200 ohm resistor by double-clicking on the resistor and changing its value. Re-calculate to determine if the zener is operating above or below the knee.
Vo2 =
© 2007 National Instruments Corporation. Permission is granted to duplicate this page for classroom use.

Name: __________________________ ID Number: ___________________ Class: ___________
Open the file IV.ms10
.
1. Draw the expected diode curve from your theory.
© 2007 National Instruments Corporation. Permission is granted to duplicate this page for classroom use.

2. Open the Oscilloscope by double-clicking on it. Run the simulation by pressing the switch to the right of the task bar or selecting Simulate/Run from the menu. You are now observing the characteristics of a silicon diode.
3. Press the red arrow key at the bottom of the window until the blue vertical marker appears. Drag the marker to the point where the diode begins to conduct. Note the voltage found at the bottom left of the window. Vf = ________________
4. Given that delta Rf = delta V/ delta I or V1 - V2 / I1 - I2, measure the voltage and current at any two points along the curve to calculate Rf. Use the voltage and current values shown at the bottom of the window.
To familiarize the student with two of Multisim’s transducers. The characteristics of both an LED and a temperature-controlled resistor are examined.
Transducers can be found in the Misc parts group, Transducers family.
1. Open Transducer.ms10
.
2. Open the Description Box and complete the steps.
3. Run the simulations by clicking on the switch or selecting Simulate/Run or clicking the switch.
© 2007 National Instruments Corporation. Permission is granted to duplicate this page for classroom use.

Three circuit files contain faults and are denoted with the letters “TS”. These faults may be observed by de-selecting the Hide component faults checkbox found under Options/Circuit Restrictions/General tab , then double-clicking on the components and sources. Providing a password will prevent student access. The use of Description Boxes is intended to guide the student through the troubleshooting process.
The troubleshooting files are Clamper1TS.ms10
, Clipper1TS.ms10
and ZenerTS.ms10.
On your NI ELVIS breadboard, create the diode circuit that you simulated and studied in the IV.ms10
file. The image below is an example implementation. Open IV.ms10
and run the simulations so you have a useful reference and a better idea of how the circuit functions.
Analog output 0 (DAC 0) is used in the circuit above to generate the AC input signal. ACH0 is used to measure the voltage across the diode while ACH1 is used to measure the current through the diode.
© 2007 National Instruments Corporation. Permission is granted to duplicate this page for classroom use.