920-0049 Patio Heater Main Burner Removal and Pilot Assembly Installation Instructions For use on model: 920-0049 Patio Heater 1 Warning Close the propane tank valve by turning it clockwise and then remove the regulator from the propane tank , before beginning any patio heater repairs or service. 920-0049 Patio Heater Main Burner Removal and Pilot Assembly Installation Instructions 2 Figure 1 • Using a crescent wrench to detach the regulator from the gas tank. Figure 1 Access to the regulator Figure 2 Figure 2 Regulator 920-0049 Patio Heater Main Burner Removal and Pilot Assembly Installation Instructions 3 • Use a Philips head screw driver to remove four screws from the base of the emitter grid. Figure 1 Emitter Base Figure 1 920-0049 Patio Heater Main Burner Removal and Pilot Assembly Installation Instructions 4 • Once the four screws are removed, lift up the emitter grid / reflector to detach it. Figure 1 Emitter Grid Figure 1 920-0049 Patio Heater Main Burner Removal and Pilot Assembly Installation Instructions 5 Figure 1 • Use a Philips head screw driver remove three screws from the top of the head assembly. Figure 1 Head assembly Figure 2 Figure 2 Figure 2 Remove screws 920-0049 Patio Heater Main Burner Removal and Pilot Assembly Installation Instructions 6 • Use a Philips head screw driver to remove three screws from the base of the head assembly. Figure 1 Base of head assembly Figure 2 Remove screws Figure 2 Figure 1 920-0049 Patio Heater Main Burner Removal and Pilot Assembly Installation Instructions 7 • Use a Philips head screw driver and remove two additional screws located on the sides of the control knob. Remove 2 Screws 920-0049 Patio Heater Main Burner Removal and Pilot Assembly Installation Instructions 8 • Pull the control knob outward to remove it. Main Burner Removal and Installation Instructions 920-0049 9 • The entire head assembly will lift up once all the previous steps have been completed Figure 1 Figure 1 Head assembly UP 920-0049 Patio Heater Main Burner Removal and Pilot Assembly Installation Instructions 10 Figure 1 • The main burner assembly will lift up and out of the head housing Figure 1 Burner assembly Figure 2 Figure 2 Housing 920-0049 Patio Heater Main Burner Removal and Pilot Assembly Installation Instructions 11 • Once the main burner assembly has been completely removed from the head housing, use a Philips head screw driver to remove two screws that hold the pilot bracket in place. The pilot assembly will detach. 920-0049 Patio Heater Main Burner Removal and Pilot Assembly Installation Instructions 12 Reassemble the patio heater using these instructions in reverse order, and perform a gas leak test pursuant to the warning and instructions in the Owner’s Manual before using your patio heater. 920-0049 Patio Heater Main Burner Removal and Pilot Assembly Installation Instructions 13