Excel Life
Trailing Edge Dimmer
EM250TR / EM400TR / EM700TR
TM
EM250TR / EM400TR
EM700TR
Operation
● Turn the knob clockwise to increase brightness.
● Turn the knob anticockwise to decrease brightness.
● Over-temperature protection If the dimmer gets too hot (due to overloading or insufficient de-rating),
the lamp brightness is automatically reduced. After the dimmer cools down, normal operation is
automatically resumed. Be sure to correct the cause of the high temperature!
Technical characteristics
Dimmable
Compact
Fluorescent
Halogen
1 dimmer
per plate
250W
250W
250VA
250VA
see note
2 dimmers
per plate
225W
225W
225VA
225VA
see note
3 dimmers
per plate
200W
200W
200VA
200VA
see note
1 dimmer
per plate
400W
400W
400VA
400VA
see note
2 dimmers
per plate
350W
350W
350VA
350VA
see note
3 dimmers
per plate
300W
300W
300VA
300VA
see note
-
700W
700W
700VA
700VA
see note
o
+ 0C
Fluorescent
tube
Incandescent
+ 50 C
Wirewound
transformer
Electronic
transformer
LED
Fan
motor
o
230 - 240V a.c.
50Hz
Max
load
EM250TR
Max
load
EM400TR
Max
load
EM700TR
1 x 2.5 mm2
2 x 1.5 mm2
25770A
Minimum load = 10VA for all load types
Note: Compact Fluorescent Lamps (CFLs), also known as Energy Saving Lamps, can only be dimmed if they are specifically marked as "dimmable". Dimmable CFLs
may have different characteristics from brand to brand, and so each brand may require a specific type of dimmer to operate correctly. Using the incorrect dimmer may
cause the CFL to flicker. Please read the documentation that comes with each CFL carefully to ensure that the CFL and dimmer are compatible. For more information,
please contact HPM Legrand. In some cases, the dimmable CFL may turn off or flicker when dimmed to a very low brightness. This can be overcome by ensuring
that the dimmer brightness is not set too low. See "Setting minimum brightness" for instructions on how to achieve this.
Wiring
Important:
Switches, powerpoints and other fixed wired products must be installed
by an electrical contractor or similarly qualified person.
EM770
Important:
When used in ambient temperatures greater than 25°C, the dimmer must be
de-rated according to the following chart.
100
One-way wiring diagram
% Rating
90
80
70
60
EM770
EM770
50
25
35
30
40
45
50
Installation air temperature (ºC)
Important:
Lamp failure of incandescent glodes mounted in the
upright position, such as candle globes, may damage
the dimmer. This is caused by the broken filament falling
down and shorting out the globe.
It is therefore recommended that incandescent globes
be mounted in the normal position.
Two-way wiring diagram
Warranty
Setting minimum brightness
● The minimum brightness can be set before the knob is put into place.
● When the unit is wired and mounted as required, switch on the power.
● Turn the potentiometer carefully by hand until the desired minimum
brightness is obtained.
● Insert the knob so that the "tongue" on the knob lines up with the slot
on the dimmer.
● Once inserted, the knob cannot be turned any further anticlockwise.
Tongue
Legrand Cat EM250TR,EM400TR and EM700TR are warranted as here and
after appears, against faulty material and/or workmanship for a period of one
year from the day of purchase. The obligation of the manufacturer under this
warranty is limited to servicing and replacing defective parts when the unit is
returned to the authorised place of purchase, at the purchaser’s cost. To obtain
warranty repair, the purchase receipt should be returned with the product. This
warranty becomes void on any unit which has been tampered with or damaged
by accident, short circuited, loaded beyond rating or damaged otherwise by
improper operation. The warranty is also conditional on the unit being installed
by a licensed electrical contractor. Our goods come with guarantees that
cannot be excluded under the Australian Consumer Law. You are entitled to a
replacement or refund for a major failure and compensation for any other loss
or damage. You are also entitled to have the goods repaired or replaced if the
goods fail to be of acceptable quality and the failure does not amount to a major
failure.
Slot
Customer Service
For all Customer Service and Technical Support
please call Monday to Friday during business hours.
HPM Legrand Australia
1300 369 777
www.hpmlegrand.com.au
25770A
HPM Legrand New Zealand
0800 476 009
www.hpmlegrand.co.nz
ABN: 31 000 102 661