Aviation Safety Products
Call for Quote
Bob Moore
Chris Kennedy
Rick Skoryk
Phone:905-405-9355
Toll Free: 1-877-814-2376
Fax: 905-405-9031
Email: sales@aerosuppliesinc.com
www.aerosuppliesinc.com
The Products
Electronic Flare Kit
LED Traffic Wand/Flashlight
E Flare Traffic Cone Attachment
Electro flare TM
Magnetic Chevron Mat TM
Collapsible Traffic Cone
Traffic Cone bag
Portable Light Tower TM
Expandable Barricade
Large Safety Cone TM
Runway light Protektor
Flexible Markers
Electronic Flare Kit
PART NUMBER: KSDFK5
This product comes with 5 flares, 5 bases and carry bag
Colors for flares available: Red, Amber, Clear, or any
combination
LED Traffic wand/flashlight
PART NUMBER: KSDEA16 (Amber wand 16” length)
PART NUMBER: KSDER16 (Red wand 16” length)
PART NUMBER: KSDEA21 (Amber wand 21” length)
PART NUMBER: KSDER21 (Red wand 21” length
E Flare Traffic Cone
Attachment
PART NUMBER: KSDTCA1
Electro-flares
PART NUMBER: KSDEF6-01
Electro-flare
High Visibility – full 360 degree coverage by 48 super bright LEDs
Versatile and Rugged
Durable and long lasting
12 hours of continuous use
Visible Flashing patterns
Eliminate risk of fire or health hazards
Available Colors: Red, Blue, Yellow, Amber, infrared and in Red/Blue, Red/Amber, Blue/Amber
Rechargeable battery pack- complete charge in four hours
supplied as marking set of 2, 4 or 6 units in storage/recharging box with full one year warranty –
including batteries
Rubber base for stability to prevent the risk of injury when hit by vehicles.
1000 recharges on set of batteries
Battery replacement service available
Weight 1 lb each
Fire proof
Magnetic Chevron Mat
PART NUMBER: KSDMC21-01 (BATTERY OPERATED)
PART NUMBER: KSDMC21-12VA-01 (12VOLT ADAPTOR)
Increase your visibility and safety
36 bright Amber LEDs
8 Tie grommets 8 high power magnets
Folds to 21” x 12” x 1.75 size and fits into carrying bag for portability
1 year limited warranty
Collapsible Traffic Cone
PART NUMBER: KSDCTC28-2-01 (FOR 2 PACK)
PARTNUMBER: KSDCTC28-6-01 (FOR 6 PACK)
PART NUMBER: KSDCTCB2-01 (POUCH HOLDS 3 TRAFFIC CONES)
PART NUMBER KSDCTCB6-01 (POUCH HOLDS 6 TRAFFIC CONES)
Reflecting Strip Surrounds Pouch
Collapsible Traffic Cone
28” Tall Extended but 2.5” Tall Collapsed
3.5 lbs, compared to standard 10 lbs
Extends and stores in seconds
Store 14 in the same area one Standard cone requires
Optional Internal & Top LED Flashing/Steady-on Lights
Optional Top LED light provides anchor for barricade
tape
LED lights can be seen from 800Ft at Night
MTO Compliant
Portable Light Tower
PART NUMBER: KSDPLT15-01
Portable Light Tower
Emergency field lighting
Illumination up to 100 000 square
feet in darkness
Telescopic light collapses in only 2
feet for easy carry & storage (2ft x
1.5 ft x 1.5 ft)
Quickly and easily installed by
single person
875 – 1000 watts full brightness in
5 minutes
Full extension 15 feet
Advertising Sleeve custom size
Made in Canada
CSA Approved
Power source 120v A.C. – 60Hz
Current requirements: 15 Amp service
Lamp: Metal Halide
Power consumed 875w-20,000 hr.
Average Life
Body: High caliber flame retardant
fiberglass
66 lbs
Resin-treated rip stop nylon
Stand colors: Red, Yellow, Blue
Custom colors, by request additional fee
Generator required to operate
1 year warranty
Expandable Barricade
PART NUMBER: KSDEB36-01
Vehicle and pedestrian traffic control
Lightweight and easy to carry quick set up
Exceptional visibility achieved with 52 reflective strips plus LED light on each post
Bottom of legs can be ballast up to 20 lbs
Weight 15 lbs maximum span 90” and 36” wide
Locks into place at desired length
Made of high density polyethylene impact and temperature resistant
Expandable Barricade
Vehicle and pedestrian traffic control
Lightweight and easy to carry quick set up
Exceptional visibility achieved with 52 reflective strips plus LED light on each post
Bottom of legs can be ballast up to 20 lbs
Weight 15 lbs maximum span 90” and 36” wide
Locks into place at desired length
Made of high density polyethylene impact and temperature resistant
Large Safety Cone
PART NUMBER: WHOPT-28-01
Outside diameter 40” Height 19”
Securing by anchor pins (4) around base of cone or by weight
Flexi-rod at apex of cone permits insertion of reflective marker
The step down edge adds to the anchoring and the extended lip eliminates weed trimming as the
lawn mower can run on the lip without damage to the marker.
Runway Light Protektor
PART NUMBER: KSDLP36-01
SAVE MONEY ELIMINATE RISKS
This unit will cover all ground exposed wires
Dimensions 30” outside circumference
26” inside circumference with 2” angle lip
Color Black
Easy to install and maintenance free
Flexible Runway Markers