LED-12W Dimming Series
Switch Mode LED Drivers
Constant Current, Dimming with Isolation
Black Magic Thermal Advantage™ Plastic Housing
Electrical Specifications
Input Voltage Range:
120-277 Vac Nom. (108-305 V Min/Max)
Frequency:
50/60 Hz Nom. (47-63 Hz Min/Max)
Power Factor:
>0.90
Inrush Current:
<10.0 Amps max @ 230 Vac, cold start 25ºC
Input Current:
0.15 Amps max at 120 Vac
Maximum Power:
12W
Line Regulation:
± 3%
Load Regulation:
± 4%
THD:
<
_ 20%
Hold Up Time:
Half Cycle
Protection:
utput Over-Voltage, Output Over-Current, and
O
Output Short Circuit Protection with Auto Recovery
Environmental Specifications
Minimum Starting Temp:
-30ºC
Storage Temperature:
-40ºC to +85ºC
Maximum Case Temp.
90°C
Humidity:
5% to 95%
Cooling:
Convection
Vibration Frequency:
5 to 55 Hz/2g, 30 minutes
Sound Rating:
Class A
MTBF:
550,000 Hours @ full load & 40ºC ambient conditions
>
per MIL-217F Notice 2
Weight:
5.8 oz (164.43 g)
• Total Power: 12 Watts
• Input Voltage: 120-277 Vac Nom.
• UL Dry & Damp Location Rated
• High Power Factor
• UL Type HL Rated for Hazardous Locations
Constant Current - Product Specifications
Model Number
Ordering Options:
-D:
Standard 0-10V & Resistance dimmable version comes with an extra two wires
+Purple/- Gray on the output side. -D 0-10V Dimming is compatible with most quality 0-10V wall dimmers. See page 3 for additional specifications.
-PD: Optional PWM version is PWM dimmable via a positive, 10% to 100% Duty Cycle,
500 Hz to 1.5k Hz, 0-10V pulse. See page 3 for additional specifications.
Sign Components Manual
E332160
Output Current Output Voltage
(mA ±4%)
Range (Vdc)
Max. Output
Typical
Power (W) Efficiency
LED12W-36-C0250-D
250
12-36
9
77%
LED12W-48-C0250-D
250
16-48
12
80%
LED12W-36-C0350-D
350
12-36
12.6
80%
LED12W-24-C0500-D
500
8-24
12
78%
LED12W-16-C0700-D
700
6-16
11.2
78%
LED12W-16-C0800-D
800
6-16
12.8
78%
LED12W-12-C1000-D
1000
4-12
12
77%
See options at left.
Class 2:
US/Canada
Safety Cert.
UL/CUL
CSA
CE
EMC Standard
EN61000-3-2
EN61000-3-3
FCC, 47CFR Part 15
Standard
UL8750
22.2
EN61347
Notes
EN6100-4-5
2KV L-N, 8/20 μsec
Surge Protection
Class C
Class B
Note:
LED drivers are designed and intended to operate LED loads only.
Non-LED loading may be outside the specified design limits of our
LED drivers, and therefore cannot be covered by any warranty.
If you desire to use our LED drivers to operate non-LED loads
please contact us to discuss compatibility.
Specifications subject to change without notice.
Thomas Research Products • 1225 Bowes Rd • Elgin, IL 60123 • T 847-515-3057 • F 847-515-3047 • www.trpssl.com
Rev 6-7-16
LED12W Dimming Series
SSL Solutions Faster Than The Speed Of Light®
Pg 2 of 3
Dimming
Purple (+)
Gray (-)
HOT SPOT
0.68 [17.35]
Output
Red (+)
Blue (-)
5.91 [150] MIN
Input
White (N)
Black (L)
2.02 [51.35]
1.48 [37.7]
5.91 [150] MIN
0.39±0.04 [10±1]
2 x Ø 0.14
[3.5]
[51.35]
0.39±0.04 [10±1]
0.64 [16.2]
4.04 [102.7]
3.77 [95.8]
0.136 [3.45]
1.21 [30.8]
0.136 [3.45]
Dimensions - IN [mm]
0.16 [4.15]
0.95 [24]
WIRE SPECS:
Input Leads: 18-AWG, Rated 600V, 105°C, min.
Output Leads: 18-AWG, Rated 600V, 105°C, min.
Dimming Leads: 22-AWG, Rated 600V, 105°C.
All wires are stranded with solder dipped ends
1.48 [37.7]
Power Factor / Load
0.90
45%
0.80
40%
0.70
35%
0.60
30%
0.50
0.40
120Vac
277Vac
0.30
25%
15%
10%
0.10
5%
60%
70%
80%
90%
Load
0%
50%
100%
Lifetime / Case Temperature
130
96%
60%
70%
80%
Load
90%
100%
Efficiency / Load
91%
90
Efficiency
Lifetime (kHrs)
115
75
60
45
86%
81%
76%
30
120Vac
277Vac
71%
15
0
120Vac
277Vac
20%
0.20
0.00
50%
THD / Load
50%
THD
PF
1.00
50
55
60
65
70
75
80
85
90
Case Hotspot Temperature (°C)
66%
50%
60%
70%
80%
Load
90%
100%
Note:
Life calculations are based on reliability with confidence using
a 90% confidence level and <5% failure rate. At a confidence
level of 90% it is expected that <5% of the parts will fail at
the rated life provided. (Failure is defined as a driver drifting
outside specification, rather than fail to operate)
Thomas Research Products • 1225 Bowes Rd • Elgin, IL 60123 • T 847-515-3057 • F 847-515-3047 • www.trpssl.com
LED12W Dimming Series
SSL Solutions Faster Than The Speed Of Light®
Pg 3 of 3
“-D” Option: 0-10VDC and Resistance Dimming
Minimum
Typical
Maximum
0 mA
-2.0 V
—
—
2mA
+15 V
Source Current out of 0-10V Purple Wire
Absolute Voltage Range on 0-10V (+) Purple Wire
Typical Dimming Circuit
Dim (+) Purple
LED12W-xxx-Cxxxx-D
IP710 Wall Dimmer
Dim (-) Gray
(Dimmer must be current-sink type control)
100
90
80
70
60
50
40
30
20
10
0
Output Current / 0-10VDC Dimming Input
Output Current %
Parameters
0V
1V
2V
3V
4V
5V
6V
Dimming Input (Vdc)
7V
8V
9V
10V
Notes:
1. 0-10V dimmable version comes with an extra two wires +Purple/-Gray on the output side.
2. Compatible with most 0-10V Wall Slide dimmers and direct 0-10V analog signal. Recommended dimmer is Leviton IP710 or equivalent
3. 0-10V dimmable version output will be <
_ 10% @ 0-1.0V
4. 0-10V dimmable version output will be 100% with Purple/Gray open and minimum with Purple/Gray Shorted.
“-PD” Option: PWM Dimming
Absolute Maximum Voltage Range on PWM Input (Purple Wire)
Input LOW Level Voltage Range (Purple Wire)
Input HIGH Level Voltage Range (Purple Wire)
Source Current out of PWM Input (Purple Wire)
PWM Input Signal Frequency
PWM Input Signal Positive Duty Cycle
PWM Positive Dimming Typical Circuit
PWM (+) Purple
LED12W-xxx-Cxxxx-PD
PWM In
Sink
PWM (-) Gray
Minimum
Typical
Maximum
-2.0 V
-2.0 V
+9.0 V
0 mA
500 Hz
0%
10 V
0V
10 V
—
—
10-90%
+15 V
+5.5 V
+15 V
2 mA
1500 Hz
100%
100
90
80
70
60
50
40
30
20
10
0
Output Current / 1.0kHz Positive Duty Cycle
Output Current %
Parameters
0%
10%
20%
30%
40%
50%
60%
Positive Duty Cycle
70%
80%
90%
Notes:
1. PD dimmable version comes with an extra 2 wires on the output side for PWM type dimming: +Purple/-Gray.
2. <10% light output <10% Duty Cycle.
3. Output will be 100% with Purple/Gray open and minimum with Purple/Gray Shorted.
Thomas Research Products • 1225 Bowes Rd • Elgin, IL 60123 • T 847-515-3057 • F 847-515-3047 • www.trpssl.com
100%