Energy Efficient Solutions
for street lighting
by
1
Agenda
The Company
The Products
The solutions for street lighting
2
3
4
5
6
The Products
As a specialist for lighting solutions VS is in the position to offer
a complete package for all light sources,
HID
 Ballasts
LED
 Chips
Fluorescent
 Ballasts
(magnetic & electronic)
 Ignitors
 LED-Boards
 Capacitors
 Capacitors
 Driver
 Lampholder
 Lampholders
7
Energy saving in street lighting
•Possible Energy savings in comparison with a Mercury Discharge lamp HM (ca. 60 lm/Watt)
•Metal halide discharge lamp HI (ca. 100 lm/Watt)
40 %
Fluorescent lamp FL (ca. 100 lm/Watt)
40 %
Sodium discharge lamp HS (ca. 130 lm/Watt)
55 %
Low pressure sodium discharge lamp LS (ca. 180 lm/Watt)
65 %
LED (cold white) (ca. 100 lm/Watt)
40 %
With a calculated adjustment of the single LED's a higher energy saving ratio (60-80 %) by a consistent illumination is
possible
120
100
Replacement of a
Mercury Discharge lamp
80
60
Power in % compared with HM
40
20
0
HM
HI/FL
HS
LED
8
Energy saving in street lighting
•Power reduction (for example from 23:00 bis 05:00 o'clock ) possible with
- Sodium high pressure (40 % Energy saving at 50 % lumen output)
- LED (possible to dim down to 1% )
•Light control systems (for example Lixos, Powerline)
Control of lighting (On/Off/Power reduction) with a central or local control unit, with fixed times or flexible with sensors.
25-30% of additional energy saving, in special projects more than that..
50
45
40
Average energy consumption
with the use of power reduction and
light control systems.
(Example for the replacement of a
Mercury Discharge lamp)
35
30
Power in % compared with HM
25
20
15
10
5
0
HS
HS with power reduction
LED
LED with controlled power
reduction
9
Ballasts and Driver for HI, HS, LS,FL and LED Lamps in standard design
or as power reduction version incl. Lampholders and accessories
•Ballasts from 24 Watt up to 2.000 Watt
• Fulfilling and beating the regulations of the ErPdirective of 2017
•With and without power reduction or dimming
Interfaces:
•Phase controlled with power switch
•DALI, PUSH, 0-10 Volt or DMX interface
•Streetlight control system like Lixos or Powerline
(with adequate nodes or slaves)
10
Compact assembly kits from 50 to 400 W
All necessary components mounted and wired
•Ballast
•Igniter
•Capacitor
•Optional power switch
•Terminal block
11
Light control and management systems
Street light control system
•Max. 255 light points
•Up to 15 groups
•Wireless remote access possible
•User-friendly programming software
Light management system based on DALI
•Up to 16 combined brightness and motion sensors
•Available with wireless key modules
•Simple, clear system configuration with additional
programming aids
• Simple system check
•Avoidance of stand-by losses trough cut off relay
contact in the Controller
12
LED light engines and drivers
Light engines
•From 2.500 to 6.800 lumen per module, modules can be combined
•Protection class IP 67
•With and without heat sink
LED drivers
•From 40 to 150 Watt
•Driving currents from 350 to 1400mA
•Up to IP67
•Dimmable
•Multiple control interface (DALI, LON, 1-10 Volt, control phase)
13