With broad spectrum of effect.
Dismozon® plus
Oxygen-active surface disinfectant cleaner. Granules specially
developed for sensitive surfaces and the final disinfection.
Research for infection protection. www.bode-science-center.com
Surfaces
Dismozon® plus
Product properties
mild, pleasant scent
low residue
exceptionally broad material
compatibility
offered in practical sachets
Composition
Active ingredient:
Magnesium monoperoxyphthalate
hexahydrate 958 mg/g.
Microbiology
bactericidal
yeasticidal
fungicidal
tuberculocidal
mycobactericidal
sporicidal
virucidal against enveloped viruses
(incl. HBV, HIV, HCV)
virucidal
Areas of application
®
Dismozon plus is suitable for the
disinfectant cleaning of washable
surfaces in a wide variety of medical
areas and the industry. Thanks to its
broad microbiological activity and the
specific active substance (MMPP) it is
recommended for routine use in sensitive
and patient-near areas, such as operating
theatres, intensive care units and
obstetric units, and for the gentle and
reliable disinfection of highly sensitive
medical devices, such as applanation
tonometers.
Directions for use
®
Dismozon plus is supplied as granules.
The use-solution must be renewed every
working day and if highly contaminated to
ensure the active oxygen level necessary
for the product’s full microbiological
effectiveness over the entire application
time.
maintenance disinfection of hard
surfaces incl. virucidal efficacy: 0.4%
1 hour exposure time
disinfection of hard surfaces in case of
special requirements: sporicidal
efficacy 1.2% 4 hours exposure time
Completely dissolve the content of
one sachet in water (use one sachet for
4 litres of water to prepare a 0.4 % usesolution).
Do not mix with cleaning agents.
Provide for adequate ventilation during
application. Possible formation of odour
may be minimised by using de-ionised
(demineralised) water.
Medical devices, (e.g. applanation
tonometers) need to be rinsed with water
after disinfection.
Please note:
Surfaces visibly contaminated with blood
need to be cleaned before using oxygenreleasing agents, otherwise their effect
may be reduced.
Use disinfectants safely. Always read the
label and product information before use.
Material compatibility
®
Dismozon plus use-solutions were
tested for their compatibility on a variety
of materials, including:
Metals: Stainless steel (V4A), aluminium.
Plastics: PA, PE, PP, PS, PVC, rubber,
®
®
®
Makrolon , Plexiglas , Teflon ,
polysulphone, POM, PUR, latex, silicone,
linoleum, Viton.
When used correctly (wipe disinfection)
material damage is not to be expected.
With copper and brass, please test
suitability in an inconspicuous area before
first use.
High-performance disinfection of sensitive surfaces with MMPP
®
®
In case sensitive medical devices made from Makrolon , Plexiglas or polysulfone
require virucidal or sporicidal disinfection, conventional active agents may damage the
material. The active oxygen magnesium monoperoxyphthalate hexahydrate, however,
is both material-friendly (1) and powerful (2, 3).
When using a special manufacturing process to granulate the MMPP, no segregation
occurs as with some powder formulations. Thus, the granules ensure a homogeneous
content of active ingredient. But also for occupational safety the granules are of
advantage: virtually no respirable dust develops.
The granules unfold their microbiological activity in combination with water only.
1 Prof. h. c. H. Hopfstock. Beurteilung der Spannungsrissbildung im Biegestreifverfahren bei Plexiglas, Polysulfon, Makrolon.
IFUS Privates Forschungsinstitut für internationale Umwelt- und Sanierungsangelegenheiten GmbH, Soltau. 16.10.1998.
2 Prof. Dr. med. J. Beckert. Sporizide Wirksamkeit von Dismozon pur. Direktor des Instituts für Hygiene der
Medizinischen Universität zu Lübeck. 09.01.1989.
Magnesium monoperoxyphthalate
hexahydrate (MMPP) is an organic
cyclical peroxide belonging to the family
of oxygenreleasing agents.
3 Dr. J. Steinmann. Viruzide Wirkung von Dismozon pur gegen Poliovirus Typ 1, Stamm Mahoney.
Staatliches Hygiene-Institut, Bremen. 17.03.1986.
Research for infection protection.
2
Dismozon® plus
Proven efficacy
Bacteria and Fungi
EN
Phase 2 / Step 1
Listing
Bactericidal (EN 13727)
- clean conditions
Efficacy according to EN Norm Phase 2 / Step 1
Yeasticidal (EN 13624)
(suspension tests),
tested under clean / dirty conditions
- clean conditions
Fungicidal (EN 13624)
- clean conditions
Tuberculocidal (EN 14348)
- clean conditions
Mycobactericidal (EN 14348)
- clean conditions
VAH
Certified application recommendations for
prophylactic wet-wipe disinfection from the
Association for Applied Hygiene (VAH). Based
on suspension and practical tests, tested under
clean conditions (i.e. optically clean surfaces) /
dirty conditions (i.e. visibly contaminated
surfaces)
Bactericidal/Yeasticidal
- clean conditions
2.0 g/l
3.0 g/l
0.2 %
0.3 %
-
30 min.
15 min.
3.0 g/l
4.0 g/l
0.3 %
0.4 %
-
1 hr.
30 min.
28.0 g/l
2.8 %
-
2 hrs.
8.0 g/l
12.0 g/l
32.0 g/l
0.8 %
1.2 %
3.2 %
-
4 hrs.
2 hrs.
1 hr.
8.0 g/l
12.0 g/l
32.0 g/l
0.8 %
1.2 %
3.2 %
-
4 hrs.
2 hrs.
1 hr.
4.0 g/l
6.0 g/l
0.4 %
0.6 %
-
1 hr.
30 min.
Certification/list issued by the
Association for Applied Hygiene (VAH)
CE-labelling in accordance with the
Medical Device Directive (MDD)
List of disinfectants and disinfectant
procedures tested and approved by the
RKI (according to § 18 lfSG)
List of tested cleaning agents for
ceramic tiling and cladding in swimming
pools (RK list)
Chemical-physical data
Appearance
0.4 % solution:
pH-value
white granules
approx. 5.8
Stability
The use-solution must be renewed
every working day.
RKI
Recognised substance for decontamination acc. Area A - veg. Bacteria (incl.
to §18 IfSG (Robert Koch-Institute [RKI])
Mycobacteria), fungi and fungi
Area B – see „Viruses“
spores.
36.0 g/l
3.6 %
-
4 hrs.
12.0 g/l
28.0 g/l
8,0 g/l
1.2 %
2.8 %
0,8 %
-
4 hrs.
2 hrs.
1 hr.
4.0 g/l
12.0 g/l
0.4 %
1.2 %
-
1 hr.
30 min.
2.0 g/l
0.2 %
-
5 min.
4.0 g/l
12.0 g/l
1,0 g/l
2,0 g/l
4.0 g/l
8.0 g/l
2.0 g/l
4.0 g/l
2.0 g/l
4.0 g/l
4.0 g/l
8.0 g/l
0.4 %
1.2 %
0,1 %
0,2 %
0.4 %
0.8 %
0.2 %
0.4 %
0.2 %
0.4 %
0.4 %
0.8 %
-
-
1 hr.
30 min.
30 min.
5 min.
2 hrs.
1 hr.
15 min.
5 min.
1 hr.
15 min.
2 hrs.
1 hr.
2.0 g/l
4.0 g/l
8.0 g/l
2.0 g/l
0.2 %
0.4 %
0.8 %
0.2 %
-
30 min.
15 min.
5 min.
1 min.
36.0 g/l
3.6 %
-
15 min.
Bacteria spores
Efficacy against bacterial spores
Sporicidal (EN 14347)
Clostridium difficile Spores
(Ribotype 027)
Viruses
EN
Phase 2 / Step 1
Efficacy according to EN Phase 2 / Step 1
(suspension tests), tested under clean / dirty
conditions
Virucidal (EN 14476)
- clean conditions
Adenovirus (EN 14476)
- clean conditions
Poliovirus (EN 14476)
- clean conditions
Efficacy against viruses (German Society for the Virucidal against enveloped
Control of Viral Diseases [DVV])
viruses (incl. HBV, HIV, HCV)
Virucidal
Appraised efficacy against non-enveloped
viruses (DVV)
Adenovirus
Polyomavirus
Poliovirus
Appraised efficacy against non-enveloped
viruses (in accordance with EN)
MNV
- clean conditions
Rotavirus
RKI
Recognised substance for decontamination
acc. to §18 IfSG (RKI)
Area A – see „Bacteria”
Area B – enveloped and
non-enveloped viruses
-
3
Presentation
16 g dosed sachet
Note: The recommendations regarding our preparations are based on scientific tests and are given in good faith. More detailed
recommendations, e.g. regarding material compatibility, are only possible in particular cases. Our recommendations are without
obligation and do not constitute a warranty. They do not preclude a company’s own testing for the intended purposes and
processes. In this respect we cannot accept any liability. This complies with our general conditions of sale and supply.
07/13
Supported by comprehensive proofs of efficacy and scientific-based research and development,
our hygiene and disinfection products ensure best possible quality.
Research for infection protection. www.bode-science-center.com
PAUL HARTMANN AG
89522 Heidenheim
Germany
For more product information visit
www.bode-chemie.com