Installation
1. Using your SAGE remote, press HOME.
2. Select Settings.
3. Select Add Devices.
4. Select Cameras.
5. Select the Indoor Camera as the camera to be added.
DSC-2132L-ES Indoor HD
Wi-Fi Camera
Package Contents
6. Follow the SAGE Home Automation Hub on-screen
prompts to pair and install the camera.
Limited Warranty
ONE YEAR LIMITED WARRANTY: Warranty details available at
SAGEbyHughes.com/warranty.
Trademarks
DCS-2132L-ES HD Wi-Fi Camera
D-Link is a registered trademark of D-Link Systems, Inc. Other trademarks
or registered trademarks are property of their respective owners.
CE Mark Warning:
CAT-5 Ethernet Cable
Power Adapter
DCS-2132L-ES
This is a Class B product. In a domestic environment, this product may
cause radio interference, in which case the user may be required to take
adequate measures.
FCC Statement:
This device complies with Part 15 of the FCC Rules. Operation is subject
to the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses
and can radiate radio frequency energy and, if not installed and used
in accordance with the instructions, may cause harmful interference to
radio communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged
to try to correct the interference by one of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
FCC Caution:
Any changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to operate
this equipment.
This transmitter must not be co-located or operating in conjunction with
any other antenna or transmitter.
IMPORTANT NOTICE:
FCC Radiation Exposure Statement:
The availability of some specific channels and/or operational frequency
bands are country dependent and are firmware programmed at the
factory to match the intended destination. The firmware setting is not
accessible by the end user.
For detailed warranty information applicable to products purchased
outside the United States, please contact the corresponding local D-Link
office.
Industry Canada Statement:
This device complies with RSS-210 of the Industry Canada Rules.
Operation is subject to the following two conditions: (1) This device
may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired
operation.
IMPORTANT NOTE:
Radiation Exposure Statement:
This equipment complies with IC radiation exposure limits set forth for
an uncontrolled environment. This equipment should be installed and
operated with minimum distance 20cm between the radiator & your
body.
Warning
Use of audio or video equipment for recording the image of a person
without their knowledge is prohibited in certain states or jurisdictions.
The end-user assumes all liability for compliance with applicable state,
local and federal laws.
This equipment complies with FCC radiation exposure limits set forth for
an uncontrolled environment. This equipment should be installed and
operated with minimum distance 20cm between the radiator & your
body.
Version 1.0(US)_ES_90x130 | April 15, 2015
RMN0101670