Pacbrake Exhaust Brake Wiring Schematic For:
Electrical Interface Wiring Diagram for Ford Kit C20002
Ford® Brake Pressure switch
NOTE:
SHADED AREA
APPLIES TO
CRUISE
CONTROL
VEHICLES ONLY
Relay
Blk./Yel.
Dash
switch
Green
Blue
Black
Blk./Yel.
OFF
Blue
Green
Red
Red
To Ford® PCM
Red
Red
To IVS
Pressure
switch
Connect to Ford® wire
(red with green tracer)
using yellow T-tap connector
86
87
87a
30
85
Ground
Black
PACBRAKE
AIR
COMPRESSOR
Red
Black
Red
Red
Green *
15 amp
fuse
Red
12V+
ignition
switched
Firewall
Green
Ground
*Commander Interface
Cut the green wire and
connect the gray wire to
solenoid side.
Gray
Wire
Ignition
Power Source
Red
Ground
White
Green
Yellow
Blue
Solder
Splice
Solder
Splice
ATS
Transmission
pin 59
Cut
Purple c/w yellow tracer
pin 29
pin 28
PCM
Powertrain Control Module
Automatic Transmission Applications Using Commander Only In This Dotted Area
Passenger Side
Behind Air Filter
Commander Connections - Ford 1999 and 2002 1/2 Vehicles
VSS Pin 59 @ ECM - dark blue with yellow tracer
For ease of installation, locate this wire at rear output speed sensor on back of transmission.
TCC Pin 28 @ ECM - purple with yellow tracer
For ease of installation, locate this wire at transmission case connector on right/center of transmission behind heat shield.
OD Pin 29 @ ECM - tan with white tracer
For ease of installation, this wire can also be found under the steering column.
Phone: 800-663-0096 • Fax: 604-882-9278 • E-mail: info@pacbrake.com • Internet: www.pacbrake.com
Pacbrake® is a registered trademark of Pacbrake Company. Other trademarks used herein are property of their respective holders. Printed in Canada
L5371.091203