ISD LV - Acuity Brands

advertisement
Catalog Number
Notes
Type
Wallbox Dimmers
FEATURES
ISD LV
INTENDED USE
To provide smooth, full-range dimming of low voltage incandescent fixtures.
These dimmers are ideally suited for use with Lithonia Lighting low-voltage
incandescent downlights or any fixtures equipped with MR 16 or other lowvoltage incandescent lamps and magnetic transformers.
ATTRIBUTES
Fluid slide movement allows fine adjustment of light level over the entire dimming range. Separate ON/OFF preset switch permits switching the lighting without disturbing the light level setting. An integral LED indicator turns ON when
the dimmer is OFF to facilitate location in a dark room. ISD series dimmers are
compatible with the Decora® series wallplates.
LOW-VOLTAGE DIMMER
CONSTRUCTION
Strap mount device is designed to fit standard single or multi-gang switchboxes.
FINISH
Standard white or ivory finish devices are supplied with a single-gang Decora®
style wallplate. Snap on color change kits are available allowing field color
change of the device to gray, black, brown, almond, white or ivory. Color change
kits include a matching single-gang Decora® style wallplate.
ELECTRICAL
Uses standard single pole or three-way wiring. No neutral connection is required.
FUNCTIONAL
Integral push ON/push OFF switch allows lighting to be switched ON and OFF at
the level currently set by the slider. Dimmers can be used with standard three-way
and four-way switches for applications requiring control from multiple locations.
Shown with optional DSA FP D1 WH screwless wallplate
(order separately)
INSTALLATION
Wall mounts over standard single gang switchbox. Devices can be ganged into
multi-gang assemblies by breaking off the scored aluminum tabs.
LISTING
UL and CSA listed.
WARRANTY
Two-year total customer satisfaction warranty.
®
Decora is a registered trademark of Leviton.
ORDERING INFORMATION
Example:
ISD 1000 LV 120 IV
Choose the boldface catalog nomenclature that best suits your needs and
write it on the appropriate line. Order accessories as separate catalog number.
ISD
ISD
Series
ISD
Capacity
600
1000
600 VA at
120 Volts
1000 VA at
120 Volts
NOTE:
1 ISD dimmers are supplied with standard
wallplates. Order optional IV ivory or WH
white screwless designer wallplates to match
dimmer.
Controls
LV
LV
LV
120
120
Lamp type
Voltage
Incandescent
(Magnetic lowvoltage transformer)
120 120 Volts
Color1
IV
WH
Ivory
White
Accessories
Order as separate item.
ISD CCKIT _ _
DSA FP D# _ _
Color change kit, specify WH (White), IV (Ivory), GY
(Gray), BR (Brown), BK (Black) or AL (Almond).
Ivory screwless thermoplastic wallplate for ISD or
Decora® compatible devices. Specify number of gangs
(# =1 to 6) and color [WH (white), IV (ivory), GY (gray), BR
(brown), BK (black) or AL (almond)].
Sheet #: ISD-LV
ISD LV Wallbox Dimmers, Low Voltage
All dimensions are inches (centimeters).
Input: 120 VAC @ 60Hz.
Integral RFI noise supression.
•
•
Standard three-way operation.
Deration required for transformer loss and multi-gang dimmer installations.
•
Lithonia recommends fusing of primary side of magnetic transformers to
protect the dimmer and/or transformer in the event of equipment failure.
3.28 (83.3 mm)
•
•
2.68 (68.1 mm)
DIMENSIONS
ELECTRICAL
4.15 (105.4 mm)
SPECIFICATIONS
DERATING TABLE
2.12 (53.8 mm)
Single-Gang
Two-Gang
More than
Two-Gang
ISD 1000 LV 120
750 W*
600 W*
525 W*
ISD 600 LV 120
450 W*
375 W*
300 W*
0.38
(9.7 mm)
WIRING DIAGRAM
Single-Location Control Application
*Includes typical transformer loss factors.
MECHANICAL
• Captured wrap around slide mechanism, 20mm total travel.
Dimmer
Cap with
Wire Connector
• Air-gap push ON/OFF preset switch.
ENVIRONMENTAL
•
1.41
(35.8 mm)
Maximum Capacity
Device
Catalog No.
Primary side of magnetic
low-voltage transformer
Red
Black
Hot (Black)
Fuse*
Black
Operating range, 0 – 55o C, 20 – 90% relative humidity, non condensing.
White
Line
120VAC, 60Hz
Green
Ground
}
Load
Black
Neutral (White)
Two-Location Control Application
Common
Terminal
(Black Screw)
Dimmer
3-Way Switch
Primary side of magnetic
low-voltage transformer
Hot (Black)
Black
Red
Fuse*
Black
Line
120VAC, 60Hz
White
Green
Ground
Green
Ground
Load
}
Black
Neutral (White)
Three-Location Control Application
Common
Terminal
(Black Screw)
4-Way Switch
3-Way Switch
Hot (Black)
Dimmer
2
Black
2
Black
1
1
Primary side of magnetic
low-voltage transformer
Red
Fuse*
Line
120VAC, 60Hz
White
Green
Ground
Green
Ground
Green
Ground
Load
}
Black
Neutral (White)
1 Travelers between switches "IN"
2 Travelers between switches "OUT"
NOTE:
* Fuse must be provided by others. See electrical specification note above.
Synergy Lighting Controls
Sheet #: ISD-LV
©2001 Acuity Brands Lighting, Inc., Rev. 10/26/07
1335 Industrial Blvd, Conyers, GA 30012
Phone: 800-533-2719
www.synergylightingcontrols.com
Download