0-10V DIMMING CONTROLLER
WIRING
INSTRUCTIONS
INST0214
PAGE 1 OF 1
INSTRUCTIONS
SAFETY INSTRUCTIONS
1. Read all instructions carefully before modifying luminaire.
2. This fixture must be wired in accordance with the national
electrical code and applicable local codes and ordinances.
3. Proper grounding is required to insure personal safety.
4. All work should be done by a qualified electrician.
WARNING:
- RISK OF ELECTRIC SHOCK -
Note: This luminaire is provided with a 0-10 Volt low voltage
dimming controller and should only be used with compatible
0-10 Volt wall dimmers. Contact manufacturer for compatible
control equipment.
1.
2.
3.
Connect the Positive (Purple) wire to the Positive wire on the compatible 0-10 Volt wall dimmer.
Connect the Negative (Grey) wire to the Negative wire on the compatible 0-10 Volt wall dimmer.
Connect the Black wire to the line side load, the White wire to the line side Common and the
Green wire to the house side ground.
Disconnect power before starting
installation or servicing luminaire.
We reserve the right to revise the design or components of any product due to parts availability or change in UL standards, without assuming any obligation or liability to modify any products previously manufactured and without notice.
This literature depicts a product DESIGN that is the SOLE and EXCLUSIVE PROPERTY of ECLIPSE LIGHTING, INC.—An Illinois Corporation. In compliance with U.S. COPYRIGHT and PATENT requirements, notification is hereby
presented in this form that this literature, or the product it depicts, is NOT to be copied, altered or used in any manner without the express written consent of, or contrary to the best interests of, ECLIPSE LIGHTING, INC.---05/04/1994
© 2011 Eclipse Lighting, Inc.
All Rights Reserved Designs
Protected by Copyright
REV. 03/01/11