MC003V SENSOR PRODUCT SUMMARY Product Type: MC003V Specification: Mount height: MAX.12m Features: 3-step dimming with 1-10v output signal and could work with any 1-10V driver to realize corridor function Detection range up to max. (Φ*H) 16m*10m, Ta. -20--+60 Rated load: SWITCH ON/OFF FUNCTION WITH DAYLIGHT SENSING With the daylight sensor enabled the sensor will only operate the lamp when the ambient light level is low. (1000 inductive & 2000 resistive) When ambient light level is below the limit set the lights will come on when movement is detected. INSTALLATION Model Number: Input Voltage: HF System: MC003V 220-240V AC 50/60Hz 5.8GHz ± 75MHz ISM Wave Band Power Consumption: ≤0.5W (Standby), <1.0W (Operation) Transmitting Power: <0.5mW Rated Load Power: 1000W (Inductive), 2000W (Resistive) Working Temperature: -25°C-70°C IP Rating: IP20 Mounting Height: Max. 12M Detection Angle: 150° Detection Area: 0.5 – 8M, Adjustable Hold Time: 10s / 30s / 90s / 3min / 20min / 30min Standby Period: 5s / 5min / 10min / 30min / 1h / Disable Standby Dimming Level: 0% / 10% / 20% / 30% / 40% / 50% Daylight Sensor: 5lux / 10lux / 30lux / 50lux / Disable Tel: +44 (0)1242 582555 When the area is vacated the light will stay illuminated for the 'hold time'. After this period the light will dim to the user defined level until movement is detected again. When the area is vacated the light will stay illuminated for the 'hold time'. After this period the light will switch off until movement is detected again. Email: sales@elssolutions.co.uk Web: www.elssolutions.co.uk Version 1.1 WIRING DIAGRAM SETTINGS 1 DETECTION AREA Detection area sets the sensitivity and range of the microwave sensor. It is simply set using the DIP switches. 2 HOLD TIME Hold-time is the time delay between the area being vacated and the light turning off. DETECTION PATTERN 3 STAND-BY DIMMING LEVEL These DIP switches are used to set the light output level after the hold time 4 STAND-BY PERIOD This is the period of time the light will remain at the dimmed level before turning off, assuming no further movement is detected Wall mounting pattern (Unit: m) Suggested installation height: 1-1.8m 5 DAYLIGHT SENSOR Each sensor contains a Daylight sensor. This setting enables the microwave sensor to operate above certain ambient light levels so the sensor can be set to only turn lights on and off in low light environments. This feature can be disabled for internal use. Ceiling mounting pattern (Unit: m) Suggested installation height 2.5-12m