S: C6L HR
Calculite, 6” LED Retrofit LED/Driver Whip Assembly
Page 1
of 3
Read and understand these instructions before installing luminaire.
This luminaire is intended for installation in accordance with the National Electrical Code
and Local Regulations. To assure full compliance with local codes and regulations, check
with your local electrical inspector before installation. To prevent electrical shock, turn off
electricity at fuse box before proceeding.
Retain these instructions for maintenance reference.
Installation Procedure for C6LRR SERIES
LICHT ENCINES with C6LRDL SERIES
FINISHINC SECTIONS
CAUTION: RISK OF FIRE: DO NOT INSTALL TRIM WITHIN 3 INCHES OF INSULATION IN SUCH A
MANNER SO AS TO ENTRAP HEAT
WARNING: RISK OF FIRE OR ELECTRIC SHOCK. LED RETROFIT INSTALLATION REQUIRES
KNOWLEDGE OF OF LUMINAIRES ELECTRICAL SYSTEMS. IF NOT QUALIFIED, DO NOT ATTEMPT
INSTALLATION. CONTACT A QUALIFIED ELECTRICIAN.
WARNING: RISK OF FIRE OF ELECTRIC SHOCK. INSTALL THIS KIT ONLY IN THE LUMINAIRES THAT
HAVE THE CONSTRUCTION FEATURES AND DIMENSIONS SHOWN IN THE PHOTOGRAPHS OR
DRAWl NGS.
CAUTION: DO NOT MAKE OR ALTER ANY OPEN HOLES IN AN ENCLOSURE OF WIRING OR
ELECTRICAL COMPONENTS DURING KIT INSTALLATION.
WARNING: TO PREVENT WIRING DAMAGE OR ABRASION, DO NOT EXPOSE WIRING TO EDGES OF
SHEET METAL OR OTHER SHARP OBJECTS.
NOTE: INSTALLATION: TO PREVENT DAMAGE TO CEILING, INSTALL INTO DRYWALL (HARD) CEILINGS
ONLY
Trims will retro—fit the following Lightolier and competitor frames
as detailed in these instructions, with the following compatability:
C6L_RR SERIES WHIP WITH C6LRDLA
SERIES FINISHING SECTION:
LIGHTOLIER: 6113, S6118, S6126, 6132,
S6132, S6142, 6213, 6218, S6218,
6226, S6226 series frames.
C6L_RR SERIES WHIP WITH C6LRDLB
SERIES FINISHING SECTION:
GOTHAM LITHONIA: 6” AF, 6” AFV series
frames
COOPER PORTFOLIO: C6042, C6142
series frames
IS: C6L_RR Rev: AD413
Specifications are subject to change without notice.
© Koninklijke Philips Electronics NV., 2012. All rights reserved
PHILIPS
•
•
••
•_•
•._•
•_•
U
U
•
U
.
.•
••—
••_
U_U U
S: C6L RH
Colculite, 6” LED Retrofit LED/Driver Whip Assembly
Page 2
of 3
Fig. B
Fig. A
INSTALLATION INSTRUCTIONS
1. TURN OFF POWER TO THE FIXTURE:
Turn off power to the fixture to prevent electric shock.
2. REMOVE EXISTING TRIM: (Fig. A)
Pull existing trim out of the coiling. Disengage the TRIM and LAMP
from the existing compact fluorescent SOCKET CUP.
3. REMOVE BALLAST AND JBOX DOOR: (Fig. B)
Remove the existing JBOX DOOR from the FRAME, and disconnect any
wiring connected to the BALLAST.
4. REMOVE UNWANTED COMPONENTS AND LEAVE SOCKET CUP:
The SOCKET CUP that exists with the FRAME should be relocated but
not removed. Cap any remaining wires and wrap with electrical tape.
Fig. C
5. PREPARE PRE-ASSEMBLED JBOX DOORIDRIVER FOR MOUNTING TO FRAME: (Fig. D)
Using pliers, remove tabs from the JBOX DOOR as required for compatability with each FRAME style as listed below. An illustration is
provided In Fig. 0 for each configuration noted:
A. Lightolier frames:
Leave Tab A (x2), and Remove Tabs B and C
B. Cooper frames:
Leave Tab C, and Remove tabs A (x2) and B
C. Gotham frames:
Leave Tab B, and Remove tabs A (x2) and C
Reach Into the opening to fix the JBOX DOOR onto the FRAME using the remaining tabs, and the existing door springs on the FRAME.
The C6L_RR WHIP will hang below the ceiling.
6. WIRE C6L_RR SERIES WHIP: (Fig. C)
Wire the THERMAL PROTECTOR (Biack wire) and LEO DRIVER (White wire) to the HOT and NEUTRAL lines, respectively. Wire ground
(Green wire) to the supply ground.
7. MOUNT JBOX DOOR TO FRAME
IS:C6L_RR Rev: A0413
Specifications are subject to change without notice.
© Koninklijke Philips Electronics NV., 2012. All rights reserved
PHILIPS
•
•._
•I
.
•—I
It •I
U
U
••—
II—
•U U
S: C6L HR
Calculite, 6” LED Retrofit LED/Driver Whip Assembly
Page 3
J—Box Door Before
Removing Tabs
of 3
After mounting
B
A
Lightolier
Configuration
Cooper
Con figu ration
Cotham
Configuration
C
A
A
B
Fig. D
Philips Lightolier
e: lol.webmaster@philips.com
t:
(508) 679—8131
w: www.lightolier.com
IS: C6L_RR
Rev A0413
Specifications are subject to change without notice.
© Koninklijke Philips Electronics NV., 2012. All rights reserved