Lift Products, Inc.
The Max-UP-Ender series is ideally suited for tipping loads up
to 90 degrees. Available with capacities of 2,000 lbs to 6,000
lbs and a variety of standard platform sizes.
The Max-UP-Enders are also available custom built for those
special handling requirements. Designs of open frame,
V-block, split platform, and special sizes are just a few of our
custom capabilities.
Capacity
LPTT-UP-20-90
2,000 lbs
LPTT-UP-40-90
4,000 lbs
LPTT-UP-60-90
6,000 lbs
Upper
Platform
Lower
Platform
24” W x 24” L
to
72” W x 72” L
24” W x 36” L
to
72” W x 72” L
Lowered
Height
10”
Note: Base frame is approximately 6" less than platform width
and 12" less than combined length of both platforms
Standard Features
• 1-1/2 hp motor. 115/230
volt single phase or
230/460 three phase
voltage
• A 30 amp dedicated
circuit is required for 115
volt operation
• Motor is internally
mounted on most models
• 10’ power cord standard
(connector not included)
• Hydraulic gear pump with
check valve, solenoid
valve, filter, and velocity
fuse standard
• Contact factory for
special electrical
requirements.
Model
• High quality chrome
plated cylinders
• One, two or three double
acting cylinders are
supplied based on capacity
& table size
• Push button magnetic
back control box standard
with 6’ cord
• Control box includes
magnetic starter
transformer, thermal
overload and fuses
• Powered up and down 90
degree tilt
• Tilt limit switch
• Color: yellow top with
blue frame
Options:
• Foot control switch
• Lowering beeper
• Remote power unit
• Safety skirting
• Custom Colors
• Adjustable tilt limit switch
• Raised base
Contact Factory
for custom options
1-262-860-1894
Designed for surface mount or lift table mounting.
Contact factory for special in-floor requirements.
*Specifications subject to change without notice
P.O. Box 349
Elm Grove, Wisconsin 53122-0349
262-860-1895 • FAX 262-860-1894
Toll Free 877-LIFTPRO (877-543-8776)
www.liftproducts.com
E-mail: lpi@liftproducts.com
M AX-UP-ENDERS
Lift Products, Inc.
MAX-UPENDER
WITH CRADLE TOP
Ideal for upending metal
coils or paper rolls. Shown
here with split upper
platform allowing shaft
placement into load.
Capacities from 2,000 to
6,000 lbs. with a variety of
custom cradles and
platform sizes.
MAX-UPENDER
WITH CUSTOM PLATFORM
Shown with an open frame platform.
This custom design allows operator
access to the upendened item
for some assembly and inspection.
Contact us with your special up-ending
requirements.
P.O.Box 349
Elm Grove,W isconsin 53122-0349
262-860-1895 • FAX 262-860-1894
TollFree877-LIFTPRO (877-543-8776)
www.liftproducts.com • lpi@ liftproducts.com
Distributed By: