BEGA
Installation and Technical Information
2413P
Wall washers with asymmetrical distribution
Tools Requir
ed:
Required:
Phillips medium screwdriver
Adjustable wrench
3mm hex key
Dimensions
B
UL listed, suitable for wet locations.
A
C
A:
10-1/4 "
B:
8-7/16 "
C:
9-5/8 "
Pr
otection Class: IP 65
Protection
Weight: 10.6 lbs.
Notice to Installer for 2413P:
1. For wall applications only.
2. Mounts directly to standard recessed 4” octagonal wiring box (by others),
using mounting kit (supplied).
3. In conformance with UL Standard 1598, a silicone based sealant must be
used between luminaire and supporting wall.
4. For up or down orientation.
Mounting plate/
Fixture back housing
Adaptor plate
4" Standard octagonal
wiring box
2413P - installation:
1. Loosen (4) 3mm hex screws and remove faceplate with lens.
2. Loosen rear screw on the fixture canopy and remove mounting plate.
3. Install (2) long 8-32 x 1 1/2” screws (provided) in the back of the adapter
plate as shown.
4. Attach adaptor plate to wiring box using (2) 8-32 x 1/2” screws provided.
Feed luminaire wires through luminaire mounting plate and adaptor plate.
5. Make supply wiring and luminaire wiring connections in the octagonal
wiring box:
MAIN VOLTAGE SUPPLY WIRE TO BLACK LUMINAIRE WIRE
NEUTRAL (COMMON) SUPPLY WIRE TO WHITE LUMINAIRE WIRE
GREEN GROUND WIRE TO GREEN LUMINAIRE WIRE
6. Note orientation labels on luminaire mounting plate. Test to make sure the
mounting plate is level by adjusting the adaptor plate, if needed.
7. Place a small bead of silicone around the back side of the mounting plate
that will come in contact with the finished wall (exterior applications only).
8. Attach mounting plate to adaptor plate over the mounting screws using the
(2) acorn nuts provided in the mounting kit. Tighten the nuts to back the
screws into the wiring box and secure the plate to the box.
9. Mount luminaire to mounting plate and tighten canopy screw to secure
luminaire. NOTE: USE ARROWS ON THE BACK OF THE LUMINAIRE TO
FIND FIXTURE ORIENTATION.
10. Insert lamp.
11. Replace faceplate with lens attached, making sure the gasket is seated
properly. The stepped side of the glass lens is the side facing out. Tighten
(4) hex screws.
Wiring box
screw
Mounting screws
Relamping/Mainten
ance
Relamping/Maintenance
Acc
essories
Accessories
Replacement Par
ts
Parts
Loosen set screw and remove trim and reflector.
Relamp. Clean luminaire and lens using only
solvent-free cleansers. Replace trim and reflector.
Tighten set screw.
Please refer to the appropriate
accessory installation sheet for
further instruction when applicable.
Description
Part No
Lens
Reflector
Lens gasket
Lampholder
Ballast (120V-277V)
140278
Consult factory
830655
74140
75390
Lamp:
(1) 42W CF triple-4p
Philips :
PL-T 42W/4P/ALTO
Osram/Sylvania :
CF42DT/E
GE :
F42TBX
In the interest of product improvement, BEGA reserves the right to make technical changes without notice.
BEGA 1000 Bega Way, Carpinteria, CA 93013 (805)684-0533 Fax (805)566-9474 www.bega-us.com © Copyright BEGA/US 2008
2413P
11/4/2008