Catalog Number Notes Type Circuit Switching Accessories FEATURES The Switching Photocell is a self-contained light-level sensor that uses an internal photoconductor cell to measure light levels. The photocell turns lighting systems OFF when natural light levels reach the user-specified setting. The time delay and deadband feature prevent cycling. The photocell may be connected to a Synergy analog input or directly to an LPCS power pack for on/off control. • Adjustable time delay • Adjustable ON light level • Adjustable OFF deadband feature • LEDs indicate unit status • Low voltage class-2 wiring • Powered from relay cabinet or LPCS power pack • Class 2 device RC PC SWITCHING PHOTOCELL ned artup. d ow y is emo vabl e th adjustment, the cur rent light ORDERING INFORMATION Catalog Number Description RC PC IN Switching Photocell for indoor applications Controls RC PC Sheet#:RCPC SYAC-150 RC PC Switching Photocell SPECIFICATIONS DIMENSIONS PHYSICAL • Indoor - mounts directly to ceiling tile or other surface. PERFORMANCE • Sensing range: indoor 10-200 FC. • Adjustable time delay: three seconds to five minutes. ELECTRICAL • Voltage: 24V DC supplied by panel. Control output; 120 mA current maximum. All dimensions are inches (millimeters) Indoor: 2-1/2"L x 2-1/2"W x 3/4"D FUNCTIONAL Specifications subject to change without notice. Light Sensor APPLICATION INFORMATION Mounting Screw Hole Menu Button The deadband feature prevents lighting systems from cycling. If light levels fall below the set ON level, the LED will be red and the lights will turn ON when the user-specified time delay has expired. Light levels will increase until the OFF level is reached. The user-set OFF level should be twice the electric lighting level plus 5 percent. If light levels exceed the OFF level, the LED will turn green and the lights will switch OFF when the time delay has expired. Select Button Mounting Screw Hole Status LED Display WIRING DIAGRAM OFF 2 R2 3 R1 4 R4 6 7 R6 8 A1 +24 IN ANALOG -RET +24V R5 RET A2 ANALOG -IN R3 R8 Blue Red Black Neut Hot Power Pack White Black R7 Control Out Blue +24 VDC in Red Common Black Occupancy Input White Yellow Cap if not used Blue Lighting Load Blue Blue 5 SYPM 8R Power Module Mounted in SYE Enclosure +24 VDC Common Control Output Red Black Blue Synergy Lighting Controls 1335 Industrial Blvd, Conyers, GA 30012 Phone: 800-533-2719 www.synergylightingcontrols.com Sheet#:RCPC ©1994 Acuity Lighting Group, Inc., Rev. 03/08 RC-PC.p65 Cap wire if not used White Yellow LB-101 COM Red ON Black PILOT LS-101 1