READ AND
FOLLOW
ALL SAFET
CUW
Series
Decorative
LED AC/Emergency
Light
SAVE
THESE INSTRUCTIONS
TO OWNER AFTER INSTA
IMPORTANT SAFEGUARDS
When using electrical equipment, basic safety precautions should
always be followed including the following:
When using electrical equipment, basic safety precautions should always be followed
•
READ AND FOLLOW ALL SAFETY
INSTRUCTIONS
Review the diagrams thoroughly before installation.
•
Do not use this equipment
for other than intended use.
INSTALLER:
•
To avoid the possibility of electric shock, turn off power supply before installation
1. To avoid the possibility of electric shock, turn off power supply before installation or servicing.
2. Review the diagrams thoroughly before installation.
Allelectrical
electrical
connections
be in accordance
with
thecodes.
NECA qualified
and local
• 3. All
connections
must be must
in accordance
with the NEC and
local
codes.
electrician should do all the work.
Donotnot
let power
cords
hot surfaces.
• 4. Do
let power
supplysupply
cords touch
hot touch
surfaces.
5. Do not mount near gas or electric heaters.
• 6. Equipment
should be
mounted
it will not be readily subject to tampering by Do not mount
near
gas inorlocations
electricwhere
heaters.
unauthorized personnel.
• 7. The
use of accessory
equipment
not recommended
by the
originalitmanufacturer
causesubject
Equipment
should
be mounted
in locations
where
will not be may
readily
to
an unsafe condition.
8. Do not use this equipment for other than intended use.
The
use of
accessory
equipment
not
recommended
by the original manufacture
• 9. All
servicing
should
be performed
by qualified
personnel
only.
•SEE UNIT LABEL FOR ADDITIONAL MODEL SPECIFICATIONS
•
All servicing should be performed by qualied personnel only.
•SAVE THESE INSTRUCTIONS FOR USE BY OWNER/OCCUPANT
NOTE: Allow battery to charge for 24 hours before rst use.
SURFACE MOUNTING
1. Separate front cover from back plate with a at blade screwdriver. Open from top s
INSTALLATION
2. Remove knock out hole in the center of the back plate. Remove knock out slots on
3. Feed AC supply leads through the center hole in the back plate. Then make the pr
for proper instructions. Cap off unused hot lead.
4. Mount back plate to junction box with provided #8-32×0.875” screws (see Figure 1
5. Attach battery connector and power connector.
6. Attach front cover to back plate (securely snaps into place).
7. Supply power and test the unit.
SURFACE CONDUIT FEED
1. Separate front cover from back plate with a at blade screwdriver. Open from top s
2. Unscrew the pipe plug from top of back plate.
3. Secure back plate to wall. Feed conduit into conduit entry opening (see Figure 3).
4. Make the proper supply lead connections. See Electrical connections section for p
5. Attach battery connector and power connector.
6. Attach front cover to back plate.
7. Supply power and test the unit.
SAVE THESE INSTR
INSTALLATION
INSTALLATION
LED
LED
LED
LED
Jumper
Connector To
Bypass Photo Sensor
Jumper
Connector To
Bypass Photo Sensor
Jumper
Connector To
Bypass Photo Sensor
LED
LED
LED
LED
Photo Sensor
Connector
Photo Sensor
OPERATION
RECYCLING INFORMATION
All steel, aluminum and
thermoplastic parts are recyclable.
All cartons contain recycled
materials.
Please recycle responsibly.
Hubbell Lighting, Inc. Life Safety Products • www.compasslightingproducts.com
© 2016 Hubbell Lighting, Inc., All Rights Reserved • Specifications subject to change without notice.
Printed in U.S.A.
603655_COM_CUW_INST_15-A
6/16