Instrumentation/ Flow Measurements














Sept 2012; “Research on New Constitutive Models for Cohesive Powder
Simulation”; Su C, Bradley MSA, Pericleous K, Patel M; CHoPS, Germany;
WCA/09/12/37
December 2011 “The Difficulties of Handling Biomass and Waste:
Characterisation of Extreme Shape Particles”; Owonikoko A, Berry RJ, Bradley
MSA; Bulk Solids Handling No 7/8; pp 366 – 371;. WC Ref: WCA/09/12/32
Sept 2010 “Review of the flowability measuring techniques for Powder
Metallurgy industry”; Kulkarni PA, Berry RJ, Bradley MSA; Proceedings of the
Institution of Mechanical Engineers, Part E: Journal of Process Mechanical
Engineering; Vol 224, no. 3/2010, pp 159 – 168,. WC Ref: WCA/09/12/29
January 2011 “Centrifugal tester versus a novel design to measure particle
adhesion strength and investigation of effect of physical characteristics (size,
shape, density) of food particles on food surfaces”; Ermis E, Farnish RFJ, Berry
RJ, Bradley MSA; Journal of Food Engineering;. WC Ref: WCA/09/12/28
Oct 2010 “Testing of powders for sensitivity to air effect segregation”; Farnish
RJ, Kulkarni P, Berry RJ, Bradley MSA, Guillebert V; EPMA 2010, Florence, Italy; ;
WC Ref: WCA/09/12/26
Sept 2010 “Characterisation of extreme shape materials: ‘biomass and waste
materials’”; Owonikoko A, Berry RJ, Bradley MSA; BulkSolids Europe 2010,
Glasgow; WC Ref: WCA/09/12/24
Sept 2010 “Centrifugal tester versus a novel design to measure particle
adhesion strength and investigation of effect of physical characteristics (size,
shape, density) of particles”; Ermis E, Farnish RJ, Berry RJ, Bradley MSA;
BulkSolids Europe 2010, Glasgow; WC Ref: WCA/09/12/23
Sept 2010 “Development of the Brookfield Powder Flow Tester”; Berry RJ,
Bradley; BulkSolids Europe 2010, Glasgow; WC Ref: WCA/09/12/21
August 2010 “Investigations on air induced segregation of pharmaceutical
powders and effect of material flow functions”; Deng T, Paul KA, Bradley MSA,
Immins L, Preston C, Scott JF, Welfare EH; Powder Technology 203 (2010) 354 –
358; WC Ref: WCA/09/12/19
July 2010 ‘Profit from Biomass’ – but can you handle it?; Bradley MSA; Clean
Technology, Clean Profits; Technology Strategy Board; Ch 4.6, pp 110 – 114; ISBN
978 0 749461171; WC ref: WCA/09/12/18
April 2010 "Development and commercialisation of a new Powder Flow Tester
for powder formulation development, quality control and equipment design"
Berry RJ, Bradley MSA, McGregor RJ; WCPT62010 conference/ PowTech 2010
exhibition; Nuremberg, Germany; WC Ref: WCA/09/12/15
March 2010 "Development and commercialisation of a new Powder Flow Tester
for powder formulation development, quality control and equipment design"
Berry RJ, Bradley MSA, McGregor RJ; BulkSolids India 2010; WC Ref:
WCA/09/12/14
August 2009 "Evolution of Wall Friction with Realistic Displacements Wall
‘Conditioning’ and the need to Measure Wall Friction over a Long Distance of
Travel" Bradley MSA, Berry RJ; 6th International Conference for Conveying and
Handling of Particulate Solids with 10th ICBMH + BULKEX; 3 – 7 August 2009;
Brisbane Australia.WC Ref: WCA/09/12/10
August 2009 "Wall Flow Function Measurements to Assess Wall Cohesion and
Adhesion" Berry RJ, Sohel MS, Bradley MSA, Reed AR; 6th International
Conference for Conveying and Handling of Particulate Solids with 10th ICBMH +
BULKEX; 3 – 7 August 2009; Brisbane Australia.WC Ref: WCA/09/12/09











August 2009 "Interpretation of Stick-Slip Powder Flow-ability Measurements"
Berry RJ, Bradley MSA, Ariza K; 6th International Conference for Conveying and
Handling of Particulate Solids with 10th ICBMH + BULKEX; 3 – 7 August 2009;
Brisbane Australia.WC Ref: WCA/09/12/08
August 2009 "Development of an Industrial On-line Powder Flowability Tester,
Results from Industrial Trials" Pillai, JR, Bradley MSA, Berry RJ, Reed AR; 6th
International Conference for Conveying and Handling of Particulate Solids with 10th
ICBMH + BULKEX; 3 – 7 August 2009; Brisbane Australia WC Ref: WCA/09/12/07
August 2009 "Comparison of available techniques for characterising the air
induced segregation tendencies of powders" Farnish RJ, Foucart CN, Kulkarni
PA, Bradley MSA, Reed AR; 6th International Conference for Conveying and
Handling of Particulate Solids with 10th ICBMH + BULKEX; 3 – 7 August 2009;
Brisbane Australia WC Ref: WCA/09/12/02
July 2009 "Direct Measurement of Powder Flavour Adhesion onto Crisp
Surface using a Novel Adhesion Tester" Ermis E, Farnish RJ, Berry RJ, Bradley
MSA; Particulate Science and Technology, 27:4; 362 – 372; WC Ref: WCA/09/12/01
Sept 2008 "Optimising plant operations for efficiency and product quality"
Farnish RJ, Bradley MSA, Deng T; BulkEurope08, Prague, Sept 2008 WC Ref:
WCA/06/08/31
April 2008 "Microwave Treatment of Oil-Contaminated Drill Cuttings at Pilot
Scale" Robinson J, Kingman S, Snape C, Bradley MSA, Bradshaw S, Thomas D,
Page P; 2008 SPE International Conference on Health, Safety and Environment in
Oil and Gas Exploration and Production; Nice, France, 15-17 April 2008 WC Ref:
WCA/06/08/29
May 2000 'Latest Developments of the Direct Technique for Measurement of the
Pneumatic conveying Characteristics of Bulk Materials', author: Dr MSA Bradley,
Dr LM Hyda, RJ Farnish. Presented at The 3rd Israeli Conference for Conveying and
Handling of Particulate Solids, May 29-June 1 2000, The Dead Sea, Israel.
April 1996 ‘The Electrostatic Charging Properties of Particulate Materials
During Pneumatic conveying’, authors: D.I. Armour-Chelu, S.R. Woodhead and
R.N. Barnes Presented at Pneumatic and Hydraulic Conveying Systems Conference,
April 21-26 1996, Palm Coast, Florida, USA organised by the Engineering
Foundation , 345 East 47th St., New York, NY, 10017, USA, and subsequently
submitted to the Journal of Powder Technology. International Referred Conference
Paper and submission under consideration for inclusion in an International Referred
Academic Journal Paper.
April 1996 ‘Electrostatic Modelling and Measurement of Airborne Particle
Concentration’, authors: A.N. Murnane, R.N. Barnes, S.R. Woodhead and J.E.
Amadi-Echendu. IEEE Transactions on Instrumentation and Measurement, Vol. 45,
No. 2, April 1996, 1-5. International Referred Academic Journal Paper.
June 1995 ‘Velocity Measurement of Pneumatically Conveyed Solids Using
Electrodynamic Sensors’. authors: Y. Yan, B. Byrne, S.R. Woodhead and J.
Coulthard. Measurement Science and Technology, Volume 6, 1995. Ref. 09570233/95/050515 Institute of Physics Publishing Ltd, London. International Refereed
Academic Journal.
April 1995 ‘Characterising Noise Signals in Two-Phase Solid/Gas Flows’.
authors: J.E. Amadi-Echendu and S.R. Woodhead. Proceedings of the IMTC
Conference on Integrating Intelligent Instrumentation and Control 1995 IEEE
Instrumentation / Measurement Technology Conference, Westin Hotel, Waltham,








Massachusets, 24-26 April 1995, published by the IEEE service centre, 445 Hoes
Lane, Piscataway, NJ 08855-1331, USA, ISBN 0-7803-2615-6, 766-769. Refereed
International Conference.
April 1995 ‘Solid Phase Velocity Measurements Utilising Electrostatic Sensors
and Cross Correlation Signal Processing Techniques’. authors: S.R. Woodhead
and J.E. Amadi-Echendu. Proceedings of the IMTC Conference on Integrating
Intelligent Instrumentation and Control 1995 IEEE Instrumentation / Measurement
Technology Conference, Westin Hotel, Waltham, Massachusets, 24-26 April 1995,
published by the IEEE service centre, 445 Hoes Lane, Piscataway, NJ 08855-1331,
USA, ISBN 0-7803-2615-6, 766-769. Refereed International Conference.
April 1995 ‘Electrostatic Modelling and Measurement of Airborne Particles
Concentration’. S.N. Murnane, R.N. Barnes, S.R. Woodhead and J.E. AmadiEchendu. Proceedings of the IMTC Conference on Integrating Intelligent
Instrumentation and Control 1995 IEEE Instrumentation / Measurement Technology
Conference, Westin Hotel, Waltham, Massachusets, 24-26 April 1995, published by
the IEEE service centre, 445 Hoes Lane, Piscataway, NJ 08855-1331, USA, ISBN 07803-2615-6, 766-769. Refereed International Conference.
Proceedings of the IMTC Conference on Integrating Intelligent Instrumentation
and Control 1995 IEEE Instrumentation / Measurement Technology Conference,
Westin Hotel, Waltham, Massachusets, 24-26 April 1995, published by the IEEE
service centre, 445 Hoes Lane, Piscataway, NJ 08855-1331, USA, ISBN 0-78032615-6, 766-769. Refereed International Conference.
April 1995 'Measurement of Pressure Profiles in Pneumatic conveying
Pipelines', authors: M.S.A. Bradley, A.J. Burnett and S.R. Woodhead, April 1995
‘Laser Doppler Velocimetry Measurements of Particle Velocity Profiles in Gas-Solid
Two Phase Flows’. authors: S.R. Woodhead, A.N. Pittman and S.J. Ashenden. 1995
IEEE Instrumentation / Measurement Technology Conference, Massachusetts, USA.
24 - 26 April 1995 ISBN 0-7803-2616-4. Refereed Conference Paper.
March 1995 ‘Results of On-Line Mass Flow Rate Measurement Tests in a Pilot
Pneumatic Coal Injection System Using an Electrostatic Measurement
Technique’. authors: S.R. Woodhead; S.J. Ashenden; and A.N. Pittman. Proc. 20th
International Conference on Coal Utilisation and Fuel Systems, Florida, USA, 1995.
ISBN No. 0-936066-20-0. International Refereed Conference Paper.
Mar 1995 ‘The Sensing of Unbalanced Pulverised Fuel Feed Rates at the Exit of
Riffle Boxes in Coal Fired Power Station Fuel Distribution Systems’. authors:
R.N. Barnes; T.P Selves and S.R. Woodhead Proc. 20th International Conference on
Coal Utilisation and Fuel Systems, Florida, USA, 1995. ISBN No. 0-936066-20-0.
International Refereed Conference Paper.
Aug. 1993 ‘The Control of Splitting Ratios at Bifurcations in Pneumatic
conveying Pipelines’. authors: T.P. Selves; R.N. Barnes; and A.R. Reed.
International Symposium on the Reliable Flow of Particulate Solids II, Oslo, Norway,
1993. ISBN No. 82-7534-003-9. International Refereed Conference Paper. Aug. 1993
‘Advances in the Design of Pneumatic Transport Systems’. authors: P.C. Arnold;
A.R. Reed; and P.W. Wypych. International Symposium on the Reliable Flow of
Particulate Solids II, Oslo, Norway, 1993. ISBN No. 82-7534-003-9. International
Refereed Conference Paper.
Aug. 1993 ‘A Hand Held Instrument for the Measurement of Dust Concentration
in Air Using an Electrostatic Sensing Technique’. authors: R.N. Barnes; S.R.
Woodhead, A.R. Reed. International Symposium on the Reliable Flow of Particulate


Solids II, Oslo, Norway, 1993. ISBN No. 82-7534-003-9. International Refereed
Conference Paper.
June 1993 ‘A Hand Held Instrument for the Measurement of Dust Concentration
in Air Using an Electrostatic Technique’. authors: R.N. Barnes; S.R. Woodhead,
A.R. Reed. Environmental Engineering, Vol. 6 No. 2, 1993. ISSN No. 0954-5824.
Journal Publication.
June 1993 ‘A Hand Held Instrument for the Measurement of Dust Concentration
in Air Using an Electrostatic Technique’. authors: R.N. Barnes; S.R. Woodhead,
A.R. Reed. The International Journal of Storing, Handling and Processing Powder,
Vol. 5 No. 2, 1993. ISSN No. 0934-7348. Journal Publication.