LGT-132B Wiring Diagram
To Connector on LGT-132
Turn Signal Switch Harness
LGT-132B
9 Pin Plug
Yellow
Driver
Headlight
+12 Volt From Battery Pack
-12 Volt To Battery Pack
12 Volt
Relay
LGT-138
Brake Light
Switch
(not included)
or Alternate
Brake Switch
Black/Silver
Black/Silver
Red/White
To Brake/Turn Signal
Fuse
Green/White
To Brake/Turn Signal
Brown/White
Passenger
Tail Light
+12 Volt To Battery Pack
Green/White
Red/Silver
Red/Blue
Red/White
Black/Silver
Brown/White
Orange
Green/Silver
Red/Blue
Ground
To Headlight
To Front Passenger Marker
Black
Red/Blue
Red/Blue
Red/White
Orange
Driver
Tail Light
Passenger
Headlight
Ground
To Tail Light/Running Light
Ground
To Tail Light/Running Light
Black/Silver
Ground
To Headlight
To Front Driver Marker
Horn
(not included)
Note: You will need to have three wire tail lights in order to install the LGT-132 Turn signal Switch. Your Tail Lights must
have two intensities; one lower intensity for running lights and one higher intensity for brake/turn signal lights. You will
also need to add a brake switch and horn to complete this turn signal package.